enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Trailer connectors in North America - Wikipedia

   en.wikipedia.org/wiki/Trailer_connectors_in...

   If you have a trailer with a lot of lights the diode and relay wiring is preferred, but if you have a trailer with a simple light arrangement it is usually sufficient to wire to 58L. In market there are many special converters [ 1 ] [ 2 ] [ 3 ] that solves the problem of connecting a car with European wiring to a trailer with North American wiring.

3. ISO standards for trailer connectors - Wikipedia

   en.wikipedia.org/wiki/ISO_standards_for_trailer...

   The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector. In these cases exclude connection for right tail light (58R) and rear fog light (54G) and connect the tail lights only to pin for left tail light (58L). [11]

4. Tow hitch - Wikipedia

   en.wikipedia.org/wiki/Tow_hitch

   The trailer tongue (North America) or coupling (outside North America) slips over a trailer hitch ball attached to a receiver hitch mount or integral with the hitch. A larger, heavy-duty gooseneck ball size: 3 in (76.2 mm) is typically used for towing greater than 10,000 pounds (4.5 t), and this towing capacity falls outside of the scope of SAE ...

5. Kickstand - Wikipedia

   en.wikipedia.org/wiki/Kickstand

   A center stand kickstand is a pair of legs or a bracket that flips straight down and lifts the rear wheel off the ground when in use. Center stands can be mounted to the chain stays right behind the bottom bracket or to the rear dropouts. Many motorcycles feature center stands in addition to side stands. The center stand is advantageous because ...

6. Gladhand connector - Wikipedia

   en.wikipedia.org/wiki/Gladhand_connector

   A pair of gladhand connectors between railroad cars A gladhand connector on a trailer. A gladhand connector or gladhand coupler is an interlocking hose coupling fitted to hoses supplying pressurized air from a tractor unit to air brakes on a semi-trailer, [1] or from a locomotive to railway air brakes on railroad cars. [2]

7. Twist-beam rear suspension - Wikipedia

   en.wikipedia.org/wiki/Twist-beam_rear_suspension

   The twist-beam rear suspension (also torsion-beam axle, deformable torsion beam, or compound crank) is a type of automobile suspension based on a large H- or C-shaped member. The front of the H attaches to the body via rubber bushings , and the rear of the H carries each stub-axle assembly, on each side of the car.