enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Tuning mechanisms for stringed instruments - Wikipedia

   en.wikipedia.org/wiki/Tuning_mechanisms_for...

   One end is pierced for the string; the other is squared off to fit in a tuning lever socket. The middle section, which would pass through the wood, is tapered. A variety of methods are used to tune different stringed instruments. Most change the pitch produced when the string is played by adjusting the tension of the strings.

3. Truss rod - Wikipedia

   en.wikipedia.org/wiki/Truss_rod

   Truss rods are frequently made out of steel, though graphite and other materials are sometimes used.. The truss rod can be adjusted to compensate for expansion or contraction in the neck wood due to changes in humidity or temperature, or to compensate for changes in the tension of the strings (the thicker the guitar string, the higher its tension when tuned to correct pitch) or using different ...

4. Capo (musical device) - Wikipedia

   en.wikipedia.org/wiki/Capo_(musical_device)

   Spring clamp capo A guitar capo with a lever-operated over-centre locking action clamp Demonstrating the peg removal feature on an Adagio guitar capo. A capo (/ ˈ k eɪ p oʊ ˌ k æ-ˌ k ɑː-/ KAY-poh, KAH-; short for capodastro, capo tasto or capotasto [ˌkapoˈtasto], Italian for "head of fretboard") [a] is a device a musician uses on the neck of a stringed (typically fretted) instrument ...

5. Stringed instrument tunings - Wikipedia

   en.wikipedia.org/wiki/Stringed_instrument_tunings

   One octave lower than 5-string bluegrass banjo. Banjo, contrabass: 3 strings 3 courses. Standard/common: E 1 A 1 D 2. Alternates: D 1 G 1 C 2; D 1 A 1 D 2; C 1 G 1 C 2; US Essentially in the same range as the bass banjo, but with a much larger resonator. These instruments are very rare, and tuning is not standardized. [6] [7] Banjo (5-string) 5 ...

6. Banjo guitar - Wikipedia

   en.wikipedia.org/wiki/Banjo_guitar

   Banjo guitar, also known as banjitar [1] or ganjo, [2] is a six-string banjo tuned in the standard tuning of a six-string guitar (E2-A2-D3-G3-B3-E4 from lowest to highest strings). The instrument is intended to allow guitar players to emulate a banjo, without learning the different tuning and fingering techniques required for the standard five ...

7. Neck (music) - Wikipedia

   en.wikipedia.org/wiki/Neck_(music)

   The "foot" is on the bottom of the neck, and affords a large gluing surface to the back of the instrument. With neck-through, making the neck part of the body. This method is used on some solid-body electric guitars, where the piece of wood that is the neck runs the entire length of the instrument and is laminated to the rest of the body. This ...

8. Elderly Instruments - Wikipedia

   en.wikipedia.org/wiki/Elderly_Instruments

   Almost every part of the guitar was damaged: the top, back, sides, fingerboard, and neck block. The worst damage, and the most challenging to repair, was caused by the neck block having punched through the back of the guitar. The owner brought the Martin to Elderly after other repair shops had rejected it as being beyond repair.

9. Banjeaurine - Wikipedia

   en.wikipedia.org/wiki/Banjeaurine

   The banjeaurine is tuned a fourth higher than the standard banjo (or like a Standard Banjo w/ a Capo on the 5th Fret), at open C major. Most notably constructed by Stewart, banjeaurines were also offered by other major banjo manufacturers, including Washburn , Fairbanks, Fairbanks & Cole , Cole , Vega , Weyman, Schall , Thompson & Odell ...