Search results
Results from the WOW.Com Content Network
A trap primer (or trap seal primer) is a plumbing device or valve that adds water to traps.The water seals in traps are needed to prevent sewer gases from entering buildings, but because this water is exposed to the air, it is subject to evaporation over time in infrequently used floor drains, leading to the release of sewer gas into the environment.
How to clean a gas stove top. If you have a gas stove top, Staph recommends the following process for cleaning it properly. What you’ll need: Cloth. Non-abrasive sponge. Dish soap. Baking soda ...
The repair for this type of problem depends on the severity of the deposits. In milder cases, a mechanic may solve the problem by adding a can of fuel-injector cleaner into the gas tank. However, in some cases, the fuel injectors must be replaced. Deposits formed on the intake valves may be removed via walnut shell blasting.
The technical requirements are outlined in Forest Service Specification FS5100-1. All spark arresters meeting the requirements of 36 CFR 261.52 must be certified and listed in the USDA Forest Service Spark Arrester Guide. This guide is a comprehensive directory of all qualified products available in the United States, and is published biannually.
A flame arrester during testing A flame arrester made for a 91 cm (36 inch) pipe weighing 10 tons. A flame arrester (also spelled arrestor), deflagration arrester, [1] or flame trap [2] is a device or form of construction that will allow free passage of a gas or gaseous mixture but will interrupt or prevent the passage of flame.
In the United States, 50% of homes had disposal units as of 2009, [12] compared with only 6% in the United Kingdom [13] and 3% in Canada. [14]In Britain, Worcestershire County Council and Herefordshire Council started to subsidize the purchase of garbage disposal units in 2005, in order to reduce the amount of waste going to landfill and the carbon footprint of garbage runs. [15]
Purge-and-trap – A flow of gas is bubbled through an aqueous sample (a beverage or aqueous extract), and the gas stream then introduced directly into the focusing trap. Solid-phase microextraction – This is based on adsorption of analytes onto a polymer-coated fibre or cartridge. [ 7 ]
The wood gas can then be filtered for tars and soot/ash particles, cooled and directed to an engine or fuel cell. [6] Most of these engines have strict purity requirements of the wood gas, so the gas often has to pass through extensive gas cleaning in order to remove or convert, i.e., "crack", tars and particles.