Ad
related to: how to calculate mold volume in water treatment method
Search results
Results from the WOW.Com Content Network
Mixed liquor suspended solids (MLSS) is the concentration of suspended solids, in an aeration tank during the activated sludge process, which occurs during the treatment of waste water. The units MLSS is primarily measured in milligram per litre (mg/L), but for activated sludge its mostly measured in gram per litre [g/L] which is equal to ...
TSS of a water or wastewater sample is determined by pouring a carefully measured volume of water (typically one litre; but less if the particulate density is high, or as much as two or three litres for very clean water) through a pre-weighed filter of a specified pore size, then weighing the filter again after the drying process that removes all water on the filter.
MFI Measuring device. The Melt Flow Index (MFI) is a measure of the ease of flow of the melt of a thermoplastic polymer.It is defined as the mass of polymer, in grams, flowing in ten minutes through a capillary of a specific diameter and length by a pressure applied via prescribed alternative gravimetric weights for alternative prescribed temperatures.
Conductivity based TDS meter in a cup of water. The two principal methods of measuring total dissolved solids are gravimetric analysis and conductivity. [4] Gravimetric methods are the most accurate and involve evaporating the liquid solvent and measuring the mass of residues left. This method is generally the best, although it is time-consuming.
Sludge Volume Index (SVI) is a process control parameter used to describe the settling characteristics of sludge in the aeration tank of an activated sludge process. [1] It was introduced by Mohlman in 1934 and has become one of the standard measures of the physical characteristics of activated sludge processes.
Suspended solids (or SS), is the mass of dry solids retained by a filter of a given porosity related to the volume of the water sample. This includes particles 10 μm and greater. Colloids are particles of a size between 1 nm (0.001 μm) and 1 μm
Activated sludge tank at Beckton sewage treatment plant, UK.The white bubbles are due to the diffused air aeration system. The activated sludge process is a type of biological wastewater treatment process for treating sewage or industrial wastewaters using aeration and a biological floc composed of bacteria and protozoa.
Upflow anaerobic sludge blanket (UASB) technology, normally referred to as UASB reactor, is a form of anaerobic digester that is used for wastewater treatment.. The UASB reactor is a methanogenic (methane-producing) digester that evolved from the anaerobic clarigester.
Ad
related to: how to calculate mold volume in water treatment method