Search results
Results from the WOW.Com Content Network
An atomic force microscope on the left with controlling computer on the right. Atomic force microscopy [1] (AFM) gathers information by "feeling" or "touching" the surface with a mechanical probe. Piezoelectric elements that facilitate tiny but accurate and precise movements on (electronic) command enable precise scanning.
Scheme of the colloidal probe technique for direct force measurements in the sphere-plane and sphere-sphere geometries. The colloidal probe technique is commonly used to measure interaction forces acting between colloidal particles and/or planar surfaces in air or in solution. This technique relies on the use of an atomic force microscope (AFM).
Kelvin probe force microscopy (KPFM), also known as surface potential microscopy, is a noncontact variant of atomic force microscopy (AFM). [ 1 ] [ 2 ] [ 3 ] By raster scanning in the x,y plane the work function of the sample can be locally mapped for correlation with sample features.
The main components of a scanning tunneling microscope are the scanning tip, piezoelectrically controlled height (z axis) and lateral (x and y axes) scanner, and coarse sample-to-tip approach mechanism. The microscope is controlled by dedicated electronics and a computer. The system is supported on a vibration isolation system. [5]
Atomic force microscope inside a FTIR spectrometer with the optical interface. The earliest measurements combining AFM with infrared spectroscopy were performed in 1999 by Hammiche et al. at the University of Lancaster in the United Kingdom, [1] in an EPSRC-funded project led by M Reading and H M Pollock.
MFM images of 3.2 Gb and 30 Gb computer hard-drive surfaces. Comparison of Faraday-effect image (left) and MFM image (inset, lower-right) of a magnetic film. Magnetic force microscopy (MFM) is a variety of atomic force microscopy, in which a sharp magnetized tip scans a magnetic sample; the tip-sample magnetic interactions are detected and used to reconstruct the magnetic structure of the ...
The atomic force microscope can be used as a nanoindenter in order to measure hardness and Young's modulus of the sample. For this application, the tip is made of diamond and it is pressed against the surface for about two seconds, then the procedure is repeated with different loads.
Non-contact atomic force microscopy (nc-AFM), also known as dynamic force microscopy (DFM), is a mode of atomic force microscopy, which itself is a type of scanning probe microscopy. In nc-AFM a sharp probe is moved close (order of Angstroms ) to the surface under study, the probe is then raster scanned across the surface, the image is then ...