Search results
Results from the WOW.Com Content Network
TE buffer is also known as T 10 E 1 buffer, which can be read as "T ten E one buffer". To make a 100 ml solution of T 10 E 1 buffer, 1 ml of 1 M Tris base (pH 10–11) and 0.2 ml EDTA (0.5 M) are mixed and made up with double distilled water up to 100ml. Add microliter amounts of high molarity HCl to lower the pH to 8.
It's important to note that the choice of storage buffer and conditions will depend on the downstream application for which the DNA is intended. For example, if the DNA is to be used for PCR, it may be stored in TE buffer at 4 degrees Celsius, while if it is to be used for long-term storage or shipping, it may be stored in ethanol at -20 ...
Under neutral conditions (pH 7-8), both DNA and RNA partition into the aqueous phase. In a last step, the nucleic acids are recovered from the aqueous phase by precipitation with 2-propanol. The 2-propanol is then washed with ethanol and the pellet briefly air-dried and dissolved in TE buffer or RNAse free water.
Lithium acetate is used in the laboratory as buffer for gel electrophoresis of DNA and RNA. It has a lower electrical conductivity and can be run at higher speeds than can gels made from TAE buffer (5-30V/cm as compared to 5-10V/cm). At a given voltage, the heat generation and thus the gel temperature is much lower than with TAE buffers ...
DEPC-treated (and therefore RNase-free) water is used in handling of RNA in the laboratory to reduce the risk of RNA being degraded by RNases. Water is usually treated with 0.1% v/v DEPC for at least 2 hours at 37 °C and then autoclaved (at least 15 min) to inactivate traces of DEPC.
A buffer solution is a solution where the pH does not change significantly on dilution or if an acid or base is added at constant temperature. [1] Its pH changes very little when a small amount of strong acid or base is added to it. Buffer solutions are used as a means of keeping pH at a nearly constant value in a wide variety of chemical ...
The highest DNA adsorption efficiencies occur in the presence of buffer solution with a pH at or below the pKa of the surface silanol groups. The mechanism behind DNA adsorption onto silica is not fully understood; one possible explanation involves reduction of the silica surface's negative charge due to the high ionic strength of the buffer.
TAE buffer is a buffer solution containing a mixture of Tris base, acetic acid and EDTA. In molecular biology, it is used in agarose electrophoresis typically for the separation of nucleic acids such as DNA and RNA. [1] It is made up of Tris-acetate buffer, usually at pH 8.3, and EDTA, which sequesters divalent cations.