enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Tape correction (surveying) - Wikipedia

    en.wikipedia.org/wiki/Tape_correction_(surveying)

    A tape not supported along its length will sag and form a catenary between end supports. According to the section of tension correction some tapes are calibrated for sag at standard tension. These tapes will require complex sag and tension corrections if used at non-standard tensions.

  3. Hogging and sagging - Wikipedia

    en.wikipedia.org/wiki/Hogging_and_sagging

    Hogging is the stress a ship's hull or keel experiences that causes the center or the keel to bend upward. Sagging is the stress a ship's hull or keel is placed under when a wave is the same length as the ship and the ship is in the trough of two waves.

  4. Marcus' method - Wikipedia

    en.wikipedia.org/wiki/Marcus'_method

    Marcus's method is a structural analysis used in the design of reinforced concrete slabs.The method was developed by Henri Marcus and described in 1938 in Die Theorie elastischer Gewebe und ihre Anwendung auf die Berechnung biegsamer Platten. [1]

  5. Sag resistance test - Wikipedia

    en.wikipedia.org/wiki/Sag_resistance_test

    Paint and other coatings that are on slanted or vertical surfaces tend to sag when first applied. The thickness of the coating as well as the composition and viscosity will affect the overall sagging and conversely the sag resistance. In order to find the sag resistance of a coating a simple test is used.

  6. Compressed earth block - Wikipedia

    en.wikipedia.org/wiki/Compressed_earth_block

    A compressed earth block (CEB), also known as a pressed earth block or a compressed soil block, is a building material made primarily from an appropriate mix of fairly dry inorganic subsoil, non-expansive clay, sand, and aggregate. Forming compressed earth blocks requires dampening, mechanically pressing at high pressure, and then drying the ...

  7. Schmidt hammer - Wikipedia

    en.wikipedia.org/wiki/Schmidt_hammer

    The test hammer hits the concrete at a defined energy. Its rebound is dependent on the hardness of the concrete and is measured by the test equipment. By reference to a conversion chart, the rebound value can be used to determine the concrete's compressive strength. When conducting the test, the hammer should be held at right angles to the ...

  8. Spancrete - Wikipedia

    en.wikipedia.org/wiki/Spancrete

    The concrete block manufacturer thrived in the rapidly growing post-World War II economy, manufacturing as many as 1,000 concrete blocks each day. By 1951, West Allis Concrete Products was receiving high-quantity orders to supply concrete block for Milwaukee County Stadium , Wisconsin State Fair Park , and Kohl's Department Stores , as well as ...

  9. BS 5400 - Wikipedia

    en.wikipedia.org/wiki/BS_5400

    BS 5400-1:1988 Steel, concrete and composite bridges. General statement. BS 5400-2:2006 Steel, concrete and composite bridges. Specification for loads. BS 5400-3:2000 Steel, concrete and composite bridges. Code of practice for design of steel bridges. (This part of standard is being partially replaced) BS 5400-4:1990 Steel, concrete and ...