enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   Spindle nose on a lathe headstock. The small female taper is a Morse taper to take a lathe center or a tool such as a twist drill. The large male taper takes a lathe chuck, which is retained by the large nut. A machine taper is a system for securing cutting tools or toolholders in the spindle of a machine tool or power tool.

3. Collet - Wikipedia

   en.wikipedia.org/wiki/Collet

   Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.

4. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   The chuck may be held against the taper with a threaded retainer ring (large thin nut), typically wrenched with a spanner wrench of the pin or hook variety. The peak of popularity for building this type of spindle nose was the 1940s and 1950s. The chuck may be held against the taper with cam-lock posts that wedge into a stuck-fast position.

5. Milling (machining) - Wikipedia

   en.wikipedia.org/wiki/Milling_(machining)

   The number refers to the Association for Manufacturing Technology (formerly the National Machine Tool Builders Association (NMTB)) taper size of the tool. A CAT-40 toolholder A boring head on a Morse taper shank. An improvement on CAT Tooling is Bridgeport Taper (BT) Tooling, which looks similar and can easily be confused with CAT tooling.

6. Talk:Machine taper - Wikipedia

   en.wikipedia.org/wiki/Talk:Machine_taper

   Morse taper is inch-based and should be defined as such. 216.152.18.131 17:17, 3 September 2020 (UTC) I was puzzled by this, too. It appears to date nearly the creation of this article. In May 2005 DerrickOswald added the Morse taper dimensions to this article, and they were the only actual dimensions in it (the article was stubbed in March of ...

7. Drill bit shank - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_shank

   Morse taper drills, from 13.5mm (with the No. 1 Morse taper shank) through to a 30mm drill (No. 4 morse taper shank) Morse Taper Drill Bit Shank. The Morse taper twist drill bits pictured right are used in metalworking. The full range of tapers is from 0 to 7. The Morse taper allows the bit to be mounted directly into the spindle of a drill ...

8. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   11/32 inch drills: long-series Morse, plain Morse, jobber. The image shows a long-series drill compared to its diametric equivalents, all are 11 ⁄ 32 inch (8.7313 mm) in diameter. The equivalent Morse taper drill shown in the middle is of the usual length for a taper-shank drill. The lower drill bit is the jobber or parallel shank equivalent.

9. Drawbar (machine tool) - Wikipedia

   en.wikipedia.org/wiki/Drawbar_(machine_tool)

   The drawbar pull is an important component that allows the milling machine to keep the tool in place while it’s being used. The force from the drawbar pull supplied to the tool has to be just right because not enough force would cause the tool to wobble leading to inaccuracy, and too much force would apply excessive stress, leading to shorter tool life.