Search results
Results from the WOW.Com Content Network
Pixel density. Pixels per inch (ppi) and pixels per centimetre (ppcm or pixels/cm) are measurements of the pixel density of an electronic image device, such as a computer monitor or television display, or image digitizing device such as a camera or image scanner. Horizontal and vertical density are usually the same, as most devices have square ...
Display size. On 2D displays, such as computer monitors and TVs, display size or viewable image size (VIS) refers to the physical size of the area where pictures and videos are displayed. The size of a screen is usually described by the length of its diagonal, which is the distance between opposite corners, typically measured in inches.
The display aspect ratio (DAR) is the aspect ratio of a display device and so the proportional relationship between the physical width and the height of the display. It is expressed as two numbers separated by a colon (x: y), where x corresponds to the width and y to the height. Common aspect ratios for displays, past and present, include 5:4 ...
A chart showing the number of pixels in different display resolutions. A display resolution standard is a commonly used width and height dimension (display resolution) of an electronic visual display device, measured in pixels. This information is used for electronic devices such as a computer monitor. Certain combinations of width and height ...
This chart shows the most common display resolutions, with the color of each resolution type indicating the display ratio (e.g., red indicates a 4:3 ratio). This article lists computer monitor, television, digital film, and other graphics display resolutions that are in common use. Most of them use certain preferred numbers.
In effect, spatial resolution is the number of independent pixel values per unit length. The spatial resolution of consumer displays ranges from 50 to 800 pixel lines per inch. With scanners, optical resolution is sometimes used to distinguish spatial resolution from the number of pixels per inch.
Front and rear views of the TVM MD-3 cathode ray tube monitor (Enhanced Graphics Adapter era). Note the DE-9 connector, cryptic mode switch, contrast and brightness controls at front, and the V-Size and V-Hold knobs at rear, which allow the control of the scaling and signal to CRT refresh rate synchronization respectively. Various computer display standards or display modes have been used in ...
A Pixel aspect ratio (often abbreviated PAR) is a mathematical ratio that describes how the width of a pixel in a digital image compared to the height of that pixel. Most digital imaging systems display an image as a grid of tiny, square pixels. However, some imaging systems, especially those that must be compatible with standard-definition television motion pictures, display an image as a ...