Search results
Results from the WOW.Com Content Network
Typically run-out is measured using a dial indicator pressed against the rotating component while it is turned. Total indicated run-out (TIR) is a technician's term for the measured run-out of any rotating system, including all forms of run-out, at the measured point.
Dial test indicators, whose tips swing in an arc rather than plunging linearly, usually have spherical tips. This shape gives point contact, allowing for consistent measurements as the tip moves through its arc (via consistent offset distance from ball surface to center point, regardless of ball contact angle with the measured surface). Several ...
A ball carves a channel through a flat plate. The action of a hardened ball against a softer, flat plate illustrates the process of burnishing. If the ball is pushed directly into the plate, stresses develop in both objects around the area where they contact. As this normal force increases, both the ball and the plate's surfaces deform.
A part's-eye view of a boring bar. Hole types: Blind hole (left), through hole (middle), interrupted hole (right). In machining, boring is the process of enlarging a hole that has already been drilled (or cast) by means of a single-point cutting tool (or of a boring head containing several such tools), such as in boring a gun barrel or an engine cylinder.
A CNC machine that operates on wood CNC machines typically use some kind of coolant, typically a water-miscible oil, to keep the tool and parts from getting hot. A CNC metal lathe with the door open. In machining, numerical control, also called computer numerical control (CNC), [1] is the automated control of tools by means of a computer. [2]
The Hopkinson pressure bar was first suggested by Bertram Hopkinson in 1914 [1] as a way to measure stress pulse propagation in a metal bar. Later, in 1949 Herbert Kolsky [2] refined Hopkinson's technique by using two Hopkinson bars in series, now known as the split-Hopkinson bar, to measure stress and strain, incorporating advancements in the cathode ray oscilloscope in conjunction with ...
The typical test uses a 10 mm (0.39 in) diameter steel ball as an indenter with a 3,000 kgf (29.42 kN; 6,614 lbf) force. For softer materials, a smaller force is used; for harder materials, a tungsten carbide ball is substituted for the steel ball. The indentation is measured and hardness calculated as:
A variety of grooves, slots, and pockets in the work-piece may be produced from a variety of tool bits. Common tool bit types are: square end cutters, ball end cutters, t-slot cutters, and shell mills. Square end cutters can mill square slots, pockets, and edges. Ball end cutters mill radiused slots or fillets.