Search results
Results from the WOW.Com Content Network
An industrial furnace, also known as a direct heater or a direct fired heater, is a device used to provide heat for an industrial process, typically higher than 400 degrees Celsius. [1] They are used to provide heat for a process or can serve as reactor which provides heats of reaction.
Basic sediment and water (BS&W) is both a technical specification of certain impurities in crude oil and the method for measuring it. When extracted from an oil reservoir, the crude oil will contain some amount of water and suspended solids from the reservoir formation. The particulate matter is known as sediment or mud.
The grain size, shape and distribution of the foundry sand, the type and quantity of bonding materials, the density to which the sand is rammed, and the percentage of moisture used for tempering the sand are important factors in regulating the degree of permeability. [1]
The steam to oil ratio is a measure of the water and energy consumption related to oil production in cyclic steam stimulation and steam assisted gravity drainage oil production. SOR is the ratio of unit of steam required to produce unit of Oil. The typical values are three to eight and two to five respectively. This means two to eight barrels ...
Submerged specific gravity is a dimensionless measure of an object's buoyancy when immersed in a fluid.It can be expressed in terms of the equation = where stands for "submerged specific gravity", is the density of the object, and is the density of the fluid.
A heated-water bath is probably the most effective method of removing foam bubbles from foaming crude oil. A heated-water bath is not practical in most oil and gas separators, but heat can be added to the oil by direct or indirect fired heaters and/or heat exchangers, or heated free-water knockouts or emulsion treaters can be used to obtain a ...
According to Greenpeace, the Canadian oil sands operations use 349 × 10 ^ 6 m 3 /a (12.3 × 10 ^ 9 cu ft/a) of water, twice the amount of water used by the city of Calgary. [152] However, in SAGD operations, 90–95% of the water is recycled and only about 0.2 volume units of water is used per volume unit of bitumen produced. [153]
In the oil industry, mud weight is the density of the drilling fluid and is normally measured in pounds per gallon (lb/gal) (ppg) or pound cubic feet (pcf) . [1] In the field it is measured using a mud scale or mud balance. Mud can weigh up to 22 or 23 ppg. A gallon of water typically weighs 8.33 pounds (or 7.48 ppg).