Search results
Results from the WOW.Com Content Network
No. 1 Croydon (formerly the NLA Tower, and colloquially the 50p Building, the Weddingcake or the Threepenny bit building) [1] is a tall building at 12–16 Addiscombe Road, Croydon, Greater London, next to East Croydon station. It was designed by Richard Seifert & Partners and completed in 1970. It has 24 storeys and is 269 feet (82 m) high.
Australasian standard three pin plug, with part insulation on the Active/Line and Neutral pins. AS/NZS 3112 is the harmonised/joint Australian and New Zealand Standard for AC power plugs (male) and sockets (female). The International Electrotechnical Commission (IEC) "world plugs" website defines this design as Plug Type I'. The plug consists ...
The term plug is in general and technical use in all forms of English, common alternatives being power plug, [1] electric plug, [2] and (in the UK) plug top. [3] The normal technical term (in both British and International English) for an AC power socket is socket-outlet , [ 4 ] but in non-technical common use a number of other terms are used.
Ungrounded (left) and grounded (right) power plugs Common North American 125-volt receptacles. All accept a 1-15P plug; the two on the left also accept grounded 5-15P plugs; the second from the left also accepts 5-20P plugs. The NEMA 5-15R device on the far left is most common; the two rightmost designs are typically seen in older buildings.
This was superseded in 1930 by BS 372 Side-Entry Wall Plugs and Sockets for Domestic Purposes Part II which states that there are only minor alterations from BS 317. In 1934, BS 372 Part II was in turn superseded by the first edition of BS 546 Two-Pole and Earthing-Pin Plugs and Socket Outlets. BS 546:1934 clause 2 specifies interchangeability ...
Generic plugs are often described by their inside diameter, such as 2.1 mm DC plugs. After the two common 5.5 mm OD (Outer Diameter) plugs, the next-most common size is 3.5 mm OD with a 1.3 mm ID (Inner Diameter), usually about 9.5 mm in length, although both longer and shorter versions also exist. These 3.5 mm OD plugs are normally used for ...
AC power plugs are also commonly circular, for example, Schuko plugs and IEC 60309. NMEA 2000 cabling using M12 connectors The M12 connector , specified in IEC 61076-2-101, is a circular electrical plug/receptacle pair with 12mm OD mating threads, used in NMEA 2000 , DeviceNet , IO-Link , some kinds of Industrial Ethernet , etc. [ 16 ] [ 17 ]
As early as 1885 a two-pin plug and wall socket format was available on the British market. By about 1910 the first three-pin earthed (grounded) plugs appeared. Over time other safety improvements were gradually introduced to the market. The earliest national [clarification needed] standard for plug and wall socket forms was set in 1915.