Search results
Results from the WOW.Com Content Network
Philco (an acronym for Philadelphia Battery Company) [1] is an American electronics manufacturer headquartered in Philadelphia. Philco was a pioneer in battery, radio, and television production. In 1961, the company was purchased by Ford and, from 1966, renamed "Philco-Ford". Ford sold the company to GTE in 1974, and it was purchased by Philips ...
The heater power is 3.6 volts and 0.225 amps. 3CN3 - High Voltage rectifier. An octal type used in color television sets. The heater power is 3.15 volts and 0.48 amps. The large current is for the advantage of fast warm-up. 3CU3 - High Voltage rectifier. An octal type used in color television sets. The heater power is 3.15 volts and 0.28 amps.
The TRANSAC S-2000/Philco 210/211 weighed about 2,000 pounds (910 kg). [19] By 1964, eighteen Model 210, eighteen Model 211 and seven Model 212 systems had been sold. [12] After Philco was purchased by Ford Motor Company, the Model 212 was introduced in 1962 [20] and released in 1963. It had 65,535 words of 48-bit memory.
The term All American Five (abbreviated AA5) is a colloquial name for mass-produced, superheterodyne radio receivers that used five vacuum tubes in their design. These radio sets were designed to receive amplitude modulation (AM) broadcasts in the medium wave band, and were manufactured in the United States from the mid-1930s until the early 1960s.
Other ceramic pieces would typically be used as a junction point between the wiring system proper, and the more flexible cloth-clad wiring found in light fixtures or other permanent, hard-wired devices. When a generic power outlet was desired, the wiring could run directly into the junction box through a tube of protective loom and a ceramic ...
A thermal switch (sometimes thermal reset or thermal cutout (TCO)) is a device which normally opens at a high temperature (often with a faint "plink" sound) and re-closes when the temperature drops. The thermal switch may be a bimetallic strip, often encased in a tubular glass bulb to protect it from dust or short circuit. Another common design ...
The Predicta Tandem model had a fully detached picture tube and an umbilical cable, which allowed the controls and speaker for the set to be next to the viewer, with the screen up to 25 feet away. Also unique to this version was a large handle over the top to carry the cathode ray tube portion wherever the viewer wanted it.
The actuator can adjust the phase angle of 0 ° el. (maximum power) up to 180 ° el. (no power). In a 50 Hz mains the controller switches every 20 ms and shows very fast behavior. As a result of the voltage flanks during switch-on, disadvantages such as EMC interference potential or control voltage output also result in ohmic loads.