Search results
Results from the WOW.Com Content Network
The company Cyclone Power Technologies of Pompano Beach, Florida was founded by inventor Harry Schoell to develop and market this engine. The Cyclone Mark V Engine is a six cylinder radial uniflow engine of two inch bore and two inch stroke. Pistons are single acting. The engine is claimed to produce 100 hp at 3,600 rpm using steam at 3,200 psi ...
A Flow Zone Unit is a term used by a Reservoir Engineer and is used in modelling the conditions in an oil reservoir. Flow units are defined with aim of better understanding reservoir unit flow behaviour and relation between porosity and permeability.
Zone valves can also be constructed using wax motors and a spring-return mechanism. In this case, the valve is normally closed by the force of the spring but can be opened by the force of the wax motor. Removal of electrical power re-closes the valve. This style of zone valve operates with a perfectly ordinary SPST thermostat.
The 6G7 series or Cyclone V6 engine is a series of V6 piston engines from Mitsubishi Motors. Five displacement variants were produced from 1986 to 2021, with both SOHC and DOHC , naturally aspirated and turbo charged layouts.
From top dead center to 34% of stroke, the crank turns through an angle of about 71°. In the six cylinder engine, one piston reaches top dead center every 360°/6 = 60°. The three cylinder WHE-DR engine only has a piston reach TDC every 120°, so its admission valve must be open over a much larger angle to ensure the engine is self-starting.
Thermoswitches or PTC thermistors which are embedded in the motor windings mostly reliably fulfil this task. They trip when the temperature limit has been exceeded and the controls switch off the motor. The positioner [1] is supplied with a setpoint [2] and an actual value [3]. The motor is controlled until the actual value is identical to the ...
A compressor map is a chart which shows the performance of a turbomachinery compressor.This type of compressor is used in gas turbine engines, for supercharging reciprocating engines and for industrial processes, where it is known as a dynamic compressor.
A fractional-horsepower motor (FHP) is an electric motor with a rated output power of less than one horsepower (745.7 W) (the term 'fractional' indicates less than one unit). There is no defined minimum output, however, it is generally accepted that a motor with a frame size of less than 35mm square can be referred to as a 'micro-motor'.