Search results
Results from the WOW.Com Content Network
A buffer solution is a solution where the pH does not change significantly on dilution or if an acid or base is added at constant temperature. [1] Its pH changes very little when a small amount of strong acid or base is added to it. Buffer solutions are used as a means of keeping pH at a nearly constant value in a wide variety of chemical ...
Buffering HF with NH 4 F results in a solution with a more stable pH; thus, more stable concentrations of HF and HF − 2, and a more stable etch rate. [2] Some oxides produce insoluble products in HF solutions. Thus, HCl may be added to BHF solutions in order to dissolve these insoluble products and produce a higher quality etch. [3]
The term quad buffering is the use of double buffering for each of the left and right eye images in stereoscopic implementations, thus four buffers total (if triple buffering was used then there would be six buffers). The command to swap or copy the buffer typically applies to both pairs at once, so at no time does one eye see an older image ...
Good's buffers (also Good buffers) are twenty buffering agents for biochemical and biological research selected and described by Norman Good and colleagues during 1966–1980. [ 1 ] [ 2 ] [ 3 ] Most of the buffers were new zwitterionic compounds prepared and tested by Good and coworkers for the first time, though some ( MES , ADA , BES , Bicine ...
The simplest way to prepare a BBS solution is to use BBS tablets. They are formulated to give a ready to use borate buffered saline solution upon dissolution in 500 ml of deionized water. Concentration of borate and NaCl as well as the pH can vary, and the resulting solution would still be referred to as "borate buffered saline".
McIlvaine buffer is a buffer solution composed of citric acid and disodium hydrogen phosphate, also known as citrate-phosphate buffer.It was introduced in 1921 by the United States agronomist Theodore Clinton McIlvaine (1875–1959) from West Virginia University, and it can be prepared in pH 2.2 to 8 by mixing two stock solutions.
Total ionic strength adjustment buffer (TISAB) is a buffer solution which increases the ionic strength of a solution to a relatively high level. This is important for potentiometric measurements, including ion selective electrodes , because they measure the activity of the analyte rather than its concentration.
TES is used to make buffer solutions. It has a pK a value of 7.550 (I=0, 25°C). [1] It is one of the Good's buffers and can be used to make buffer solutions in the pH range 6.8–8.2. It is one of the components of Test yolk buffer medium used for refrigeration and transport of semen.