enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Oil pump (internal combustion engine) - Wikipedia

   en.wikipedia.org/wiki/Oil_pump_(internal...

   [c] These are supplementary pumps and do not replace the main, mechanical, oil pump. Electric pump as a main engine pump again will require big electric motors and it may be simply cheaper to drive directly from the engine. For e.g. BMW S65 engine's oil pump delivers ca. 45 LPM (Litres Per Minute) of oil at 5.5 bar pressure. [5]

3. Motor soft starter - Wikipedia

   en.wikipedia.org/wiki/Motor_soft_starter

   A motor soft starter is a device used with AC electrical motors to temporarily reduce the load and torque in the powertrain and electric current surge of the motor during start-up. This reduces the mechanical stress on the motor and shaft, as well as the electrodynamic stresses on the attached power cables and electrical distribution network ...

4. Starter (engine) - Wikipedia

   en.wikipedia.org/wiki/Starter_(engine)

   An automobile starter motor (larger cylinder). The smaller object on top is a starter solenoid which controls power to the starter motor and engages the Bendix drive.. A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power.

5. ASCO Power Technologies - Wikipedia

   en.wikipedia.org/wiki/ASCO_Power_Technologies

   The "Firetrol" branch of ASCO provides power transfer switches, controls, and alarms for fire suppression. ASCO's headquarters is located in Florham Park, New Jersey . With over 1400 employees and 500,000 square feet of manufacturing floor space, it is the world's largest manufacturer of power transfer switches.

6. Aircraft engine starting - Wikipedia

   en.wikipedia.org/wiki/Aircraft_engine_starting

   Another problem is the reluctance of the fuel to vaporise and combust at low temperatures. Oil dilution systems were developed (mixing fuel with the engine oil), [8] and engine pre-heaters were used (including lighting fires under the engine). The Ki-Gass priming pump system was used to assist starting of British engines. [9]

7. Fluid coupling - Wikipedia

   en.wikipedia.org/wiki/Fluid_coupling

   The oil may be pumped back into the coupling when needed, or some designs use a gravity feed - the scoop's action is enough to lift fluid into this holding tank, powered by the coupling's rotation. Scoop control can be used for easily managed and stepless control of the transmission of very large torques.