enow.com Web Search

  1. Ads

    related to: terminal test leads

Search results

  1. Results from the WOW.Com Content Network
  2. Test probe - Wikipedia

    en.wikipedia.org/wiki/Test_probe

    Test probes range from very simple, robust devices to complex probes that are sophisticated, expensive, and fragile. Specific types include test prods, oscilloscope probes and current probes. A test probe is often supplied as a test lead, which includes the probe, cable and terminating connector.

  3. Four-terminal sensing - Wikipedia

    en.wikipedia.org/wiki/Four-terminal_sensing

    Four-point measurement of resistance between voltage sense connections 2 and 3. Current is supplied via force connections 1 and 4. In electrical engineering, four-terminal sensing (4T sensing), 4-wire sensing, or 4-point probes method is an electrical impedance measuring technique that uses separate pairs of current-carrying and voltage-sensing electrodes to make more accurate measurements ...

  4. Contact resistance - Wikipedia

    en.wikipedia.org/wiki/Contact_resistance

    In a four-terminal measurement, the current used to make the measurement is injected using a second, separate pair of leads, so the contact resistance of the measurement probes and their leads is not included in the measurement. Specific contact resistance can be obtained by multiplying by contact area.

  5. Multimeter - Wikipedia

    en.wikipedia.org/wiki/Multimeter

    Multimeter test leads. A multimeter can use many different test probes to connect to the circuit or device under test. Crocodile clips, retractable hook clips, and pointed probes are the three most common types. Tweezer probes are used for closely spaced test points, as for instance surface-mount devices. The connectors are attached to flexible ...

  6. Lead (electronics) - Wikipedia

    en.wikipedia.org/wiki/Lead_(electronics)

    Lead frame of a surface-mount technology package. Most kinds of integrated circuit packaging are made by placing a silicon chip on a lead frame, wire bonding the chip to the metal leads of the lead frame, and covering the chip with plastic. The metal leads protruding from the plastic are then either "cut long" and bent to form through-hole pins ...

  7. Test light - Wikipedia

    en.wikipedia.org/wiki/Test_light

    The test light is an electric lamp connected with one or two insulated wire leads. [1] Often, it takes the form of a screwdriver with the lamp connected between the tip of the screwdriver and a single lead that projects out the back of the screwdriver. By connecting the flying lead to an earth (ground) reference and touching the screwdriver tip ...

  8. Sense (electronics) - Wikipedia

    en.wikipedia.org/wiki/Sense_(electronics)

    In electronics, sense is a technique used in power supplies to produce the correct voltage for a load.Although simple batteries naturally maintain a steady voltage (except in cases of large internal impedance), a power supply must use a feedback system to make adjustments based on the difference between its intended output and its actual output.

  9. Banana connector - Wikipedia

    en.wikipedia.org/wiki/Banana_connector

    Additionally, the test lead wire must be made with insulation rated for higher voltages. In most European countries, the standard mains power receptacle will physically accept banana and even US-style "double banana" plugs (the standard US pin spacing of 3 ⁄ 4 inch (19 mm) is close enough to the mains plug spacing of about 19 mm, and the pin ...

  1. Ads

    related to: terminal test leads