Search results
Results from the WOW.Com Content Network
The core (or gas generator) of the engine must generate enough power to drive the fan at its rated mass flow and pressure ratio. Improvements in turbine cooling/material technology allow for a higher (HP) turbine rotor inlet temperature, which allows a smaller (and lighter) core, potentially improving the core thermal efficiency.
The engine, with a fan diameter of 134 in (340 cm), is installed in a 174 in (440 cm) diameter nacelle, with 1.5 ft (0.46 m) of ground clearance. [17] The engine and nacelle weighed 40,000 lb (18 t) with its new pylon and wing strengthening, compared to 17,000 lb (7.7 t) for the CF6-80C2s and its pylon.
The CFM56 is a high-bypass turbofan engine (most of the air accelerated by the fan bypasses the core of the engine and is exhausted out of the fan case) with several variants having bypass ratios ranging from 5:1 to 6:1, generating 18,500 to 34,000 lbf (80 kN to 150 kN) of thrust. The variants share a common design, and differ only in details.
GEnx on 747-8I prototype. As of 2016, the GEnx and the Rolls-Royce Trent 1000 were selected by Boeing following a run-off between the three big engine manufacturers. The GEnx uses some technology from the GE90 turbofan, [1] including swept composite fan blades and the 10-stage high-pressure compressor (HPC) featured in earlier variants of the engine.
The General Electric CF6, US military designations F103 and F138, is a family of high-bypass turbofan engines produced by GE Aviation. Based on the TF39, the first high-power high-bypass jet engine, the CF6 powers a wide variety of civilian airliners. The basic engine core also powers the LM2500 and LM6000 marine and power generation turboshafts.
This tip-turbine driven lift-fan concept was turned 90 degrees and developed as an 80-inch-diameter "cruise fan" demonstrator, driven by a J79 gas generator. [4] For the CX-X program GE demonstrated a half-scale engine, the GE1/6, with 15,830 lb thrust and an sfc of 0.336. [8] This was developed into the TF39 with a 97 in diameter fan.
The Honeywell HTF7000 is a turbofan engine produced by Honeywell Aerospace.Rated in the 6,540–7,624 lbf (29.09–33.91 kN) range, the HTF7000 is used on the Bombardier Challenger 300/350, Gulfstream G280, Embraer Legacy 500/450 and the Cessna Citation Longitude.
The engine is used on the A220, A320neo family, Embraer E-Jet E2 and the Russian Yakovlev MC-21 (although exports were stopped as part of the international sanctions during the Russian invasion of Ukraine). The Pratt & Whitney PW1000G engine family initially garnered significant interest from airlines due to its touted fuel efficiency advantages.