enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Ridgid - Wikipedia

   en.wikipedia.org/wiki/Ridgid

   The Ridge Tool Company is an American manufacturing company that makes and distributes tools under the Ridgid brand name. The company was founded in 1923 in North Ridgeville, Ohio . [ 1 ] In 1943, it relocated to its current location in Elyria, Ohio , and in 1966, it became a wholly owned subsidiary of Emerson Electric .

3. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

4. Yankee screwdriver - Wikipedia

   en.wikipedia.org/wiki/Yankee_screwdriver

   There were 3 different size spring chucks, and therefore 3 different shank size tips or sometimes called points, to fit various models. Generally all tips made by North Brothers or Stanley were stamped with the corresponding number of the model screwdriver they would fit, but the stamped numbers are often difficult to see, so it's a good idea to know the size you need before you set out to ...

5. Brace (tool) - Wikipedia

   en.wikipedia.org/wiki/Brace_(tool)

   A brace and bit can be used to drill wider and deeper holes than can a geared hand-powered drill. The cost of the greater torque is lower rotational speed; it is easy for a geared hand drill to achieve a rotational speed of several hundred revolutions per minute, while it would require considerable effort to achieve even 100 rpm with a brace.

6. Drill bit shank - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_shank

   One particular type of reduced-shank drill bits are Silver & Deming (S&D) bits, whose sets run from 9 ⁄ 16-inch (14 mm) to 1 + 1 ⁄ 2-inch (38 mm) drill body diameter with a standard 1 ⁄ 2-inch (13 mm) reduced shank for all. This allows drill presses with 1 ⁄ 2-inch (13 mm) chucks to run the larger drills. S&D bits are 6 inches (150 mm ...

7. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   So a 1 / 2 in (12.7 mm) diameter drill will be able to drill a hole 4 + 1 / 2 in (114.3 mm) deep, since it is 9 times the diameter in length. A 1 / 8 in (3.175 mm) diameter drill can drill a hole 1 + 5 / 8 in (41.275 mm) deep, since it is 13 times the diameter in flute length. [3]