enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Screw thread - Wikipedia

   en.wikipedia.org/wiki/Screw_thread

   This is known as a right-handed (RH) thread, because it follows the right-hand grip rule. Threads oriented in the opposite direction are known as left-handed (LH). By common convention, right-handedness is the default handedness for screw threads. Therefore, most threaded parts and fasteners have right-handed threads. Left-handed thread ...

3. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   A special type of bolt that is set into concrete, with screw threads protruding above the concrete surface to accept a nut. breakaway bolt: A breakaway bolt is a bolt with a hollow threaded shank, which is designed to break away upon impact. Typically used to fasten fire hydrants, so they will break away when hit by a car. Also used in aircraft ...

4. Turnbuckle - Wikipedia

   en.wikipedia.org/wiki/Turnbuckle

   It normally consists of two threaded eye bolts, one screwed into each end of a small metal frame, one with a conventional right-hand thread and the other with a left-hand thread. The tension can be adjusted by rotating the frame, which causes both eye bolts to be screwed in or out simultaneously, without twisting the eye bolts or attached ...

5. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   Most screws are tightened by clockwise rotation, which is called a right-hand thread. [4] [5] Screws with a left-hand thread are used in exceptional cases, such as where the screw will be subject to counterclockwise torque, which would tend to loosen a right-hand screw. For this reason, the left-side pedal of a bicycle has a left-hand thread. [6]

6. List of thread standards - Wikipedia

   en.wikipedia.org/wiki/List_of_thread_standards

   Unified Miniature Screw Threads: V Thread Form: 0.60 UNM ANSI/ASME B1.11-1958 (R2016) Microscope Objective Thread: V Thread Form ASME B1.13M-2005 (R2015) Metric Screw Threads: M Profile: V Thread Form ASME B1.15-1995 (R2003) Unified Inch Screw Threads (UNJ Thread Form) V Thread Form ASME B1.20.1-2013: Pipe Threads, General Purpose (Inch) Pipe ...

7. Square thread form - Wikipedia

   en.wikipedia.org/wiki/Square_thread_form

   When there is no suffix it is a single start thread. If there is a suffix then the value after the multiplication sign is the lead and the value in the parentheses is the pitch. For example: would denoted two starts, as the lead divided by the pitch is two. The "LH" denotes a left hand thread. [2]