enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Crimp (joining) - Wikipedia

   en.wikipedia.org/wiki/Crimp_(joining)

   Crimp tool for 0.14 mm 2 to 10 mm 2 (26–8 AWG) insulated and non-insulated ferrules. Crimping is a method of joining two or more pieces of metal or other ductile material by deforming one or both of them to hold the other.

3. Ferrule - Wikipedia

   en.wikipedia.org/wiki/Ferrule

   A wire rope terminated with a ferrule (left) and a thimble (right) Picco pipe with nickel silver ferrule Non-circular ferrules holding bristles of a brush to its handle. A ferrule (a corruption of Latin viriola "small bracelet", under the influence of ferrum "iron") is any of a number of types of objects, generally used for fastening, joining, sealing, or reinforcement.

4. Air-line fitting - Wikipedia

   en.wikipedia.org/wiki/Air-line_fitting

   One side is connected to a flexible supply hose; the other may be attached to a manifold, valve, tool, or another hose. A female coupler is used on the supply side, and a male nipple is used on the receiving side. Fitting profiles have identifiable geometry on the male end, but care must be taken to use a compatible coupler.

5. Crimp - Wikipedia

   en.wikipedia.org/wiki/Crimp

   Crimp or crimping may refer to: . Crimp (climbing), a small hold with little surface area Crimp (gambling), a bent corner of a card to facilitate cheating Crimp (joining), a deformity in metal or food dough used to make a joint.

6. Compression fitting - Wikipedia

   en.wikipedia.org/wiki/Compression_fitting

   A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect

7. Hose clamp - Wikipedia

   en.wikipedia.org/wiki/Hose_clamp

   The hose is then fit onto the barb, the clamp expanded again, slid onto the portion of the hose over the barb, then released, compressing the hose onto the barb. Clamps of this design are rarely used for high pressures or large hoses, as they would require unwieldy amounts of steel to generate enough clamping force, and be impossible to work ...