enow.com Web Search

  1. Ads

    related to: environmolds liquid latex mold making rubber coating spray for plastic bottles

Search results

  1. Results from the WOW.Com Content Network
  2. Liquid latex - Wikipedia

    en.wikipedia.org/wiki/Liquid_latex

    Due to the presence of ammonium hydroxide, liquid latex may cause skin irritation and eye irritation. The amount of ammonium varies greatly, and depends on the latex's intended use. Liquid Latex intended for mold-making may cause serious eye irritation. [5] If liquid latex gets in your eyes, rinse cautiously with water for several minutes.

  3. RTV silicone - Wikipedia

    en.wikipedia.org/wiki/RTV_silicone

    Silicones are usually very thick (high viscosity), and must be vacuum degassed prior to pouring, to minimize bubble entrapment. If making a brush-on rubber mold, the curing time factor between coats is long (longer than urethanes or polysulfides, shorter than latex). Silicone components (A+B) must be mixed accurately by weight (scale required ...

  4. Foam latex - Wikipedia

    en.wikipedia.org/wiki/Foam_latex

    To create foam latex, a liquid latex base is mixed with various additives and whipped into a foam, then poured or injected into a mold and baked in an oven to cure.The main components of foam latex are the latex base, a foaming agent (to help it whip into a froth), a gelling agent (to convert the liquid foam into a gel), and a curing agent (to turn the gelled foam latex into a solid when baked).

  5. Release agent - Wikipedia

    en.wikipedia.org/wiki/Release_agent

    A release agent (also mold release agent, release coating, or mold release coating) is a chemical used to prevent other materials from bonding to surfaces. Release agents aid in processes involving mold release, die-cast release, plastic release, adhesive release, and tire and web release. [ 1 ]

  6. Spin casting - Wikipedia

    en.wikipedia.org/wiki/Spin_casting

    The spin casting process typically uses vulcanized silicone or organic rubber as the mold-making substrate. Vulcanization is an integral step that occurs halfway through the mold-making process. Prior to vulcanization, the mold rubber is a soft and malleable solid-like fluid, in many ways very similar to Silly Putty. Because of the clay-like ...

  7. Injection molding of liquid silicone rubber - Wikipedia

    en.wikipedia.org/wiki/Injection_molding_of...

    Injection molding of liquid silicone rubber (LSR) is a process to produce pliable, durable parts in high volume.. Liquid silicone rubber is a high purity platinum cured silicone with low compression set, good stability and ability to resist extreme temperatures of heat and cold ideally suitable for production of parts, where high quality is required.

  8. Spray bottle - Wikipedia

    en.wikipedia.org/wiki/Spray_bottle

    While spray bottles existed long before the middle of the 20th century, they used a rubber bulb which was squeezed to produce the spray; the quickly-moving air siphoned fluid from the bottle. The rapid improvement in plastics after World War II increased the range of fluids that could be dispensed, and reduced the cost of the sprayers because ...

  9. Thermoplastic elastomer - Wikipedia

    en.wikipedia.org/wiki/Thermoplastic_elastomer

    Fabrication via injection molding is extremely rapid and highly economical. Both the equipment and methods normally used for the extrusion or injection molding of a conventional thermoplastic are generally suitable for TPEs. TPEs can also be processed by blow molding, melt calendaring, [7] thermoforming, and heat welding.

  1. Ads

    related to: environmolds liquid latex mold making rubber coating spray for plastic bottles
  1. Related searches environmolds liquid latex mold making rubber coating spray for plastic bottles

    how to paint latex moldmold release agent