enow.com Web Search

  1. Ads

    related to: dana 44 front axle bearings diagram

Search results

  1. Results from the WOW.Com Content Network
  2. Dana 44 - Wikipedia

    en.wikipedia.org/wiki/Dana_44

    The Dana 44 Front axle first saw use in the 1950s and still in use today. Dana 44 Front axles were known for utilizing locking hubs or a center axle disconnect system. However, a permanently locked-in Dana 44 is not uncommon. The Dana 44 has seen use in 1/4-, 1/2-, 3/4-, and 1-ton rated trucks.

  3. GM 10.5-inch 14-bolt differential - Wikipedia

    en.wikipedia.org/wiki/GM_10.5-inch_14-bolt...

    The 10.5" 14-bolt differential and axle is quite popular with Jeep Wrangler owners who want to upgrade their standard Dana 30, Dana 35, or Dana 44 axle. While the 10.5" 14-bolt axle is heavier than the standard Dana axles offered on the Wrangler, it is much stronger.

  4. Dodge Ramcharger - Wikipedia

    en.wikipedia.org/wiki/Dodge_Ramcharger

    In 1978, when the part-time 4WD system was introduced, the front Dana 44 was equipped with a more conventional front wheel bearing design and automatic locking hubs. Late in the 1984 model year, the Dana 44 was switched to a CAD (Center Axle Disconnect) version. The CAD Dana 44 was vacuum-actuated by a switch on the transfer case and powered by ...

  5. Chevrolet K5 Blazer - Wikipedia

    en.wikipedia.org/wiki/Chevrolet_K5_Blazer

    The four-wheel drive version had a solid front axle and used leaf springs front and rear. The two-wheel drive version came with independent front suspension and rear trailing arms, both with coil springs. Both versions used drum brakes on all four wheels until 1971, when the entire GM light truck line was fitted with front discs as standard ...

  6. Dana 70 - Wikipedia

    en.wikipedia.org/wiki/Dana_70

    Both companies used Dana 70 front axles until the mid-1970s (Dodge W300 pickup up until 1978, discontinued in 1979). All of these Dana 70 front axles were closed knuckle, with king pins and had a GAWR of 6000 lbs. Like the rear Dana 70 axles, the Dana 70 front axle started out with 23 spline axle shafts and then went to 35 spline axle shafts.

  7. Dana 50 - Wikipedia

    en.wikipedia.org/wiki/Dana_50

    Dana 50's were made as front axles only until it was revived in rear solid axle configuration in the 2022 Ford Bronco Raptor. The Dana 50 has a "50" cast into the housing and is regarded to have more strength than a Dana 44, but not as much as a Dana 60. It was only produced in a reverse cut gear set aka a high pinion.

  1. Ads

    related to: dana 44 front axle bearings diagram