Ads
related to: rotary drilling rig parts
Search results
Results from the WOW.Com Content Network
Drill bit (#26) is a device attached to the end of the drill string that breaks apart the rock being drilled. It contains jets through which the drilling fluid exits. Drill floor (#21) is the area on the rig where the tools are located to make the connections of the drill pipe, bottom hole assembly, tools and bit. It is considered the main area ...
A drawworks is the primary hoisting machinery component of a rotary drilling rig.Its main function is to provide a means of raising and lowering the traveling block.The wire-rope drill line winds on the drawworks drum and over the crown block to the traveling block, allowing the drill string to be moved up and down as the drum turns.
In this simple diagram of a drilling rig, #20 (in blue) is the rotary table. The kelly drive (#19) is inserted through the center of the rotary table and kelly bushings, and has free vertical (up & down) movement to allow downward force to be applied to the drill string, while the rotary table rotates it.
Rotary assemblies [2] are commonly used where formations are predictable and the rig economics are an issue. In such an assembly the weight of the drill collars gives the BHA the tendency to sag or flex to the low side of the hole, collar stiffness length and stabiliser diameter and placement are engineered as a means of controlling the flex of the BHA.
An automated drill rig (ADR) is an automated full-sized walking land-based drill rig that drills long lateral sections in horizontal wells for the oil and gas industry. [8] ADRs are agile rigs that can move from pad to pad to new well sites faster than other full-sized drilling rigs. Each rig costs about $25 million.
Simple diagram of a drilling rig and its basic operation. The kelly drive is #19. A kelly drive is a type of well drilling device on an oil or gas drilling rig that employs a section of pipe with a polygonal (three-, four-, six-, or eight-sided) or splined outer surface, which passes through the matching polygonal or splined kelly (mating) bushing and rotary table.
Regardless of type, drill bits must satisfy two primary design goals: maximize the rate of penetration (ROP) of the formation and provide a long service life. The reason for this is a direct consequence of the rotary drilling method. Modern oilfield drilling operations require substantial capital and operating expense.
The top drive allows the drilling rig to drill the longer section of a stand of drill pipe in one operation. [1] A rotary table type rig can only drill 30-foot (9.1 m) (single drill pipe) sections of drill pipe whereas a top drive can drill 60–90-foot (18–27 m) stands (double and triple drill pipe respectively, a triple being three joints of drillpipe screwed together), depending on the ...
Ads
related to: rotary drilling rig parts