Search results
Results from the WOW.Com Content Network
Center of gravity (CG) limits are specified longitudinal (forward and aft) and/or lateral (left and right) limits within which the aircraft's center of gravity must be located during flight. The CG limits are indicated in the airplane flight manual. The area between the limits is called the CG range of the aircraft. Weight and Balance
Clark Y is the name of a particular airfoil profile, widely used in general purpose aircraft designs, and much studied in aerodynamics over the years. The profile was designed in 1922 by Virginius E. Clark using thickness distribution of the German-developed Goettingen 398 airfoil. [1]
The KF airfoil was designed by Richard Kline and Floyd Fogleman. Aircraft wing showing the KFm4 Step. In the early 1960s, Richard Kline wanted to make a paper airplane that could handle strong winds, climb high, level off by itself and then enter a long downwards glide.
Yawing also increases the speed of the outboard wing whilst slowing down the inboard wing, with corresponding changes in drag causing a (small) opposing yaw moment. N r {\displaystyle N_{r}} opposes the inherent directional stiffness which tends to point the aircraft's nose back into the wind and always matches the sign of the yaw rate input.
The NACA four-digit wing sections define the profile by: [2] First digit describing maximum camber as percentage of the chord. Second digit describing the distance of maximum camber from the airfoil leading edge in tenths of the chord. Last two digits describing maximum thickness of the airfoil as percent of the chord. [3]
Hand-launching an UMX Radian. Hand launching is the simplest way to get a model glider into the air. Depending on craft design and the conditions at launch—the pilot or an assistant need only to gently 'throw' it into the wind, at an angle deemed best suited, usually between horizontal and 45 degrees of zenith.
where M is the pitching moment, q is the dynamic pressure, S is the wing area, and c is the length of the chord of the airfoil. is a dimensionless coefficient so consistent units must be used for M, q, S and c. Pitching moment coefficient is fundamental to the definition of aerodynamic center of an airfoil.
Mean aerodynamic chord (MAC) is defined as: [6] = (), where y is the coordinate along the wing span and c is the chord at the coordinate y.Other terms are as for SMC. The MAC is a two-dimensional representation of the whole wing. The pressure distribution over the entire wing can be reduced to a single lift force