Search results
Results from the WOW.Com Content Network
Schematic diagram of an opto-isolator showing source of light (LED) on the left, dielectric barrier in the center, and sensor (phototransistor) on the right [note 1]. An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical signals between two isolated circuits by using light. [1]
A common design principle of these devices is a special galvanic isolation module between the input (control) and the output (switching) circuits of the relay. Interface relays are widely used in control and protection systems of high voltage (10-100 kV) electronic and electrophysical equipment and in high power installations. [3] [5] [6]
Opto-isolator VTL2C1 with LED input and photoresistor output. Resistive opto-isolator (RO), also called photoresistive opto-isolator, vactrol (after a genericized trademark introduced by Vactec, Inc. in the 1960s), analog opto-isolator [notes 1] or lamp-coupled photocell, [1] is an optoelectronic device consisting of a source and detector of light, which are optically coupled and electrically ...
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.
An opto-isolator is a very popular method of isolation in digital circuits. Cross-section of dual in-line package opto-isolators. Relative sizes of LED (red) and sensor (green) are exaggerated. Everlight EL817 phototransistor opto-isolator in DIP-4 package Halo TG110-S050N2RL 10/100BASE-TX Ethernet pulse transformer in SO-16 package.
English: A diagram of a simple circuit using an optocoupler. When the switch S' 1 is closed, the diode emits light and the transistor conducts. v' out thus goes low. This circuit therefore acts much like a logicalNOT gate.
Example Ladder Logic Diagram. The schematic diagrams for relay logic circuits are often called line diagrams, because the inputs and outputs are essentially drawn in a series of lines. A relay logic circuit is an electrical network consisting of lines, or rungs, in which each line or rung must have continuity to enable the output device. A ...
Closed-loop regulator circuits using the TL431 are always designed to operate in high transconductance mode, with I CA no less than 1 mA (point D on the current-voltage curve). [ 8 ] [ 7 ] [ 2 ] For better control loop stability, optimal I CA should be set at around 5 mA, although this may compromise overall efficiency.