enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Trench drain - Wikipedia

   en.wikipedia.org/wiki/Trench_drain

   Trench drains are commonly confused with French drains, which consist of a perforated pipe that is buried in a gravel bed, and which are used to evacuate ground water. A slot drain , also wrongly associated with a trench drain, consists of a drainage pipe with a thin neck (or slot) that opens at the ground surface with sufficient opening to ...

3. Washer (hardware) - Wikipedia

   en.wikipedia.org/wiki/Washer_(hardware)

   An archaic form of this washer was sold as a "pot mender", usually in small quantities through a retail ironmonger. This included two washers, a nut, and bolt, and a sealing washer of rubber, cork, or fibre sheet. They could be used for sealing small holes, rust spots or removed pipe connections in water tanks or large cooking vessels.

4. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   A threaded fastener for joining two male threads, most commonly a threaded rod,[1][2] but also pipes Flange nut: Collar nut Has a wide flange at one end that acts as an integrated washer HARDLOCK Nut [3] Eccentric Double Nut A self-lock nut. Improvement of the double nut that uses a wedge principal, eliminating space between threads. Insert nut

5. List of vacuum tubes - Wikipedia

   en.wikipedia.org/wiki/List_of_vacuum_tubes

   Some specify which end of the filament is to be powered by the positive side of the filament power supply (usually a battery). All have glass bodies that measure from 0.285 to 0.400 inches (7.2 to 10.2 millimetres) wide, and from 1.25 to 2.00 inches (32 to 51 millimetres) in overall length. 1C8 – Pentagrid converter, R8

6. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   where is the tap drill size, is the major diameter of the tap (e.g., 3 ⁄ 8 in for a 3 ⁄ 8-16 tap), and / is the thread pitch (1 ⁄ 16 inch in the case of a 3 ⁄ 8-16 tap). For a 3 ⁄ 8-16 tap, the above formula would produce 5 ⁄ 16, which is the correct tap drill diameter. The above formula ultimately results in an approximate 75% thread.

7. 3D printing filament - Wikipedia

   en.wikipedia.org/wiki/3D_printing_filament

   3D printing filament in different colours with models created using the filament. 3D printing filament is the thermoplastic feedstock for fused deposition modeling 3D printers.