Search results
Results from the WOW.Com Content Network
A properly designed crankcase breather will also be designed in a manner that promotes the scavenging effect, or the creation of suction within the crankcase breather to further aid in the removal of blow-by gases. It is this effect that keeps the crankcase at slightly negative pressure when a properly functioning PCV system is in place. [9]
The vent/rollover valve provides a method of controlled escape for gasoline vapors during the refueling process. It has a mechanism which closes the vent in the event the vehicle rolls over, to prevent spilling of VOCs or fuel in general. It also acts as a fill limiter. [8] [dead link ]
A crankcase is the housing in a piston engine that surrounds the crankshaft. In most modern engines, the crankcase is integrated into the engine block. Two-stroke engines typically use a crankcase-compression design, resulting in the fuel/air mixture passing through the crankcase before entering the cylinder(s). This design of the engine does ...
The crankcase heater is normally on all the time, even when the unit is not running, though temperature sensors and set points may turn it off when not needed. A crankcase heater's sole purpose is to prevent refrigerant migration and mixing with crankcase oil when the unit is off, and to prevent condensation of refrigerant in the crankcase of a ...
Engine bay lighting; Fog light (also called foglamp); Spotlight; Headlight (also called headlamp) . Headlight motor; Interior light and lamp, . Center dome, Vanity-Sun visor and rear side, Floor and Door-front, back, Boot lamp or Trunk lamp
Many early closed cars, such as the 1933 Pontiac Economy Eight had front and rear vent windows called "ventiplanes" and were installed on all GM products that year. It has hinges and a latch, so it can be opened for additional ventilation. 1933 was the first year all GM vehicles were installed with optional vent windows which were initially called "No Draft Individually Controlled Ventilation ...
Where the connecting rods are at different locations along the crankshaft (which is the case unless fork-and-blade connecting rods are used), this offset creates a rocking couple within the engine. V4 engines come in many different configurations in terms of the 'V' angle and crankshaft configurations.
[8] [9] Using portable generators in garages, or near open windows or air conditioning vents can also result in carbon monoxide poisoning. [10] Additionally, it is important to prevent backfeeding when using a portable engine generator, which can harm utility workers or people in other buildings. Before turning on a diesel- or gasoline-powered ...