Search results
Results from the WOW.Com Content Network
Most bowlers use three holes (thumb and two fingers,). On past, one could drill additional holes on other parts of the bowling ball, to take additional weight off of a portion of the bowling ball, such as an axis hole that allows the bowling ball's hook to stabilize during its roll to the pins. Doctoring the bowling ball by adding additional ...
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
For a right-handed bowler, the ball proceeds down the lane, usually using a left-to-right line, and strikes the right side of the 1-pin. At this point, the ball will proceed to move down the front row of pins in the direction opposite its spin - the 1-3-6-10 pins. This type of a hit is referred to as "riding the rail" among spinners.
Take the left end and tuck it to the right, under the first end and then to the left under the upper center part of the knot. The knot should now have a regular over-one-and under-one sequence throughout. Still keeping the knot in hand, tuck both ends under the rim and up through the center compartment of the knot as pictured in the third diagram.
The bow is held with all five fingers of the right hand, the thumb opposite the fingers and closer to the cellist's body. The shape of the hand should resemble that of its relaxed state, with all fingers curved, including the thumb. The wrist would slightly tilt toward the strings when making an up bow, keeping the bow straight when moving.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Thumb method – create a loop and push the working end through the loop with your thumb. Overhand method – create a bight, by twisting the hand over at the wrist and sticking your hand in the hole, pinch the working end with your fingers and pull through the loop.
To properly fasten or unfasten a screw, one applies the above rules: if a screw is right-handed, pointing one's right thumb in the direction of the hole and turning in the direction of the right hand's curled fingers (i.e. clockwise) will fasten the screw, while pointing away from the hole and turning in the new direction (i.e. counterclockwise ...