enow.com Web Search

  1. Ads

    related to: furutech dps 4.1 power cable amplifier

Search results

  1. Results from the WOW.Com Content Network
  2. DisplayPort - Wikipedia

    en.wikipedia.org/wiki/DisplayPort

    The DisplayPort standard does not specify any maximum length for cables, though the DisplayPort 1.2 standard does set a minimum requirement that all cables up to 2 meters in length must support HBR2 speeds (21.6 Gbit/s), and all cables of any length must support RBR speeds (6.48 Gbit/s).

  3. Differential amplifier - Wikipedia

    en.wikipedia.org/wiki/Differential_amplifier

    A differential amplifier is a type of electronic amplifier that amplifies the difference between two input voltages but suppresses any voltage common to the two inputs. [1] It is an analog circuit with two inputs and + and one output , in which the output is ideally proportional to the difference between the two voltages:

  4. Class-D amplifier - Wikipedia

    en.wikipedia.org/wiki/Class-D_amplifier

    For very high power amplification the power loss of class-AB amplifiers is unacceptable. Amplifiers with several kilowatts of output power are available as class D. Class-D power amplifiers are available that are rated at 3000 W total output, yet weigh only 3.6 kg (8 lb). [11] Bass instrument amplification

  5. Speaker wire - Wikipedia

    en.wikipedia.org/wiki/Speaker_wire

    The voltage on a speaker wire depends on amplifier power; for a 100-watt-per-channel amplifier, the voltage will be about 30 volts RMS. At such voltage, a 1% loss will occur at 0.3 ohms or more of inductive reactance. Therefore, to keep audible (up to 20,000 Hz) losses below 1%, the total inductance in the cabling must be kept below about 2 μH.

  6. Power over Ethernet - Wikipedia

    en.wikipedia.org/wiki/Power_over_Ethernet

    Standards-based Power over Ethernet is implemented following the specifications in IEEE 802.3af-2003 (which was later incorporated as Clause 33 into IEEE 802.3-2005) or the 2009 update, IEEE 802.3at. The standards require Category 5 cable or better for high power levels but allow using Category 3 cable if less power is required. [27]

  7. 5.1 surround sound - Wikipedia

    en.wikipedia.org/wiki/5.1_surround_sound

    A prototype for five-channel surround sound, then dubbed "quintaphonic sound", was used in the 1975 film Tommy. [6]5.1 dates back to 1976, [7] when Dolby Labs modified the track usage of the six analogue magnetic soundtracks on Todd-AO 70 mm film prints.

  1. Ads

    related to: furutech dps 4.1 power cable amplifier