Ad
related to: metal furring vs stud trim
Search results
Results from the WOW.Com Content Network
Vertical, metal furring is applied to the wall to create a channel and receive the siding material. In construction, furring (furring strips) are strips of wood or other material applied to a structure to level or raise the surface, to prevent dampness, to make space for insulation, to level and resurface ceilings or walls, [1] or to increase the beam of a wooden ship.
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
In light-frame construction, a trimmer is a timber or metal beam (joist) used to create an opening around a stairwell, skylight, chimney, and the like. Trimmers are installed parallel to the primary floor or ceiling joists and support headers, which run perpendicular to the primary joists.
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.
Battens are also used in metal roofing to secure the sheets called a batten-seam roof and are covered with a batten roll joint. [2] Some roofs may use a grid of battens in both directions, known as a counter-batten system, which improves ventilation. Roofing battens are most commonly made of wood or metal, but can be made of other materials.
wall studs (subsidiary upright limbs in framed walls), for example, close studding. The horizontal timbers include: sill-beams (also called ground-sills or sole-pieces, at the bottom of a wall into which posts and studs are fitted using tenons), noggin-pieces (the horizontal timbers forming the tops and bottoms of the frames of infill panels),
Blocking placed as attachment points for cabinets, while doubling as bracing against compression of the studs. Blocking ( dwang , nog, noggin, and nogging) is the use of short pieces of dimensional lumber in wood framed construction to brace longer members or to provide grounds for fixings.
Timber framing is a general term for building with wooden posts and beams. The term post is the namesake of other general names for timber framing such as post-and-beam, post-and-girt construction and more specific types of timber framing such as Post and lintel, post-frame, post in ground, and ridge-post construction.
Ad
related to: metal furring vs stud trim