enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Lathe center - Wikipedia

   en.wikipedia.org/wiki/Lathe_center

   Dead center (the conical piece) mounted in the spindle of a lathe and being used to support a workpiece being driven by a carrier setup. A lathe center, often shortened to center, is a tool that has been ground to a point to accurately position a workpiece on an axis.

3. Froe - Wikipedia

   en.wikipedia.org/wiki/Froe

   Froes are similar in general form to axes, in that a froe is an L-shaped assembly of a blade head (typically steel) set at a right angle to a handle called a haft (traditionally wood). A froe can be thought of as an axe which is sharpened along the top of a long, narrow, rectangular head, instead of (as the axe is) at the end of a broad curved ...

4. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   In wood, the brad point drill bit is another solution: the center of the drill bit is given not the straight chisel of the twist drill bit, but a spur with a sharp point, and four sharp corners to cut the wood. While drilling, the sharp point of the spur pushes into the soft wood to keep the drill bit in line.

5. Gimlet (tool) - Wikipedia

   en.wikipedia.org/wiki/Gimlet_(tool)

   A gimlet is a hand tool for drilling small holes, mainly in wood, without splitting. It was defined in Joseph Gwilt's Architecture (1859) as "a piece of steel of a semi-cylindrical form, hollow on one side, having a cross handle at one end and a worm or screw at the other".

6. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1] When drilling larger holes, where the drill bit is wider than the indentation produced by a center punch, the drilling of a pilot hole is usually needed.

7. Pocket-hole joinery - Wikipedia

   en.wikipedia.org/wiki/Pocket-hole_joinery

   When joining boards at a right angle, it is important that the cuts are precise and square to prevent gaps or un-perpendicular joints between the boards. Some woodworkers lay out their project before drilling their pocket holes and mark the face of the board that they want to drill to ensure the hole is in the correct location.