enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Serpentine belt - Wikipedia

   en.wikipedia.org/wiki/Serpentine_belt

   Serpentine belt (foreground) and dual vee belt (background) on a bus engine Belt tensioner providing pressure against the back of a serpentine belt in an automobile engine. A serpentine belt (or drive belt [1]) is a single, continuous belt used to drive multiple peripheral devices in an automotive engine, such as an alternator, power steering pump, water pump, air conditioning compressor, air ...

3. Belt (mechanical) - Wikipedia

   en.wikipedia.org/wiki/Belt_(mechanical)

   The ideal belt is that of the lowest tension that does not slip in high loads. Belt tensions should also be adjusted to belt type, size, speed, and pulley diameters. Belt tension is determined by measuring the force to deflect the belt a given distance per inch (or mm) of pulley.

4. BAS hybrid - Wikipedia

   en.wikipedia.org/wiki/BAS_hybrid

   A 36-volt lead–acid battery (housed in the vehicle's trunk and operating in a 42-volt electrical system) is used to operate a permanent magnet motor/generator unit mounted to the engine in a similar fashion to a conventional alternator. Then, through a high-tension drive belt, the motor/generator unit is capable of starting or assisting the ...

5. Distributor - Wikipedia

   en.wikipedia.org/wiki/Distributor

   In older distributors, adjusting the ignition timing is usually achieved through both mechanical advance and vacuum advance. Mechanical advance adjusts the timing based on the engine speed (rpm), using a set of hinged weights attached to the distributor shaft. These weights cause the breaker points mounting plate to slightly rotate, thereby ...

6. Capstan equation - Wikipedia

   en.wikipedia.org/wiki/Capstan_equation

   A flat belt has an effective angle of =. The material of a V-belt or multi-V serpentine belt tends to wedge into the mating groove in a pulley as the load increases, improving torque transmission. [6] For the same power transmission, a V-belt requires less tension than a flat belt, increasing bearing life. [5]

7. Automobile auxiliary power outlet - Wikipedia

   en.wikipedia.org/wiki/Automobile_auxiliary_power...

   The actual voltage, matching the car battery's voltage, will be approximately 12.5 volts when dormant (less in cold conditions), approximately 14.5 volts when the engine and the alternator/generator are operating (more when cold), and may briefly drop as low as 5–6 volts during engine start due to the high temporary battery current usage. [12]