Search results
Results from the WOW.Com Content Network
Last, multiply the original expression of the physical value by the fraction, called a conversion factor, to obtain the same physical value expressed in terms of a different unit. Note: since valid conversion factors are dimensionless and have a numerical value of one , multiplying any physical quantity by such a conversion factor (which is 1 ...
There are anecdotal objections to the use of metric units in carpentry and the building trades, on the basis that it is easier to remember an integer number of inches plus a fraction than a measurement in millimeters, [9] or that foot-inch measurements are more suitable when distances are frequently divided into halves, thirds, and quarters ...
The template is intended for conversion of heights specified in either metres or in feet and inches. Template parameters [Edit template data] Parameter Description Type Status Metres m metre metres meter meters The height in metres. Do not use if feet and inches are specified. Number optional Centimetres cm centimetre centimetres centimeter centimeters The height in centimetres. Do not use if ...
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
The actual size of the drive bays differ from their name (e.g., 3 1 ⁄ 2" drive bays are actually 4 inches (101.6 mm) wide, because 3 1 ⁄ 2" refers to the historical platter diameter inside the drive). The newer 2 1 ⁄ 2 inch and 1.8 inch drive bays are specified in
8.47 mm = 1 ⁄ 3 of an inch, the notional base unit under the Composition of Yards and Perches. Digit: 19.05 mm = 3 ⁄ 4 inch Finger: 22.23 mm = 7 ⁄ 8 inch Inch: 25.4 mm: 3 barleycorns (the historical legal definition) Nail (cloth) 57.15 mm: 3 digits = 2 + 1 ⁄ 4 inches = 1 ⁄ 16 yard Palm: 76.2 mm: 3 inches Hand: 101.6 mm: 4 inches ...