enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Ethernet over USB - Wikipedia

   en.wikipedia.org/wiki/Ethernet_over_USB

   Ethernet over USB is the use of a USB link as a part of an Ethernet network, resulting in an Ethernet connection over USB (instead of e.g. PCI or PCIe).. USB over Ethernet (also called USB over Network or USB over IP) is a system to share USB-based devices over Ethernet, Wi-Fi, or the Internet, allowing access to devices over a network.

3. Power over Ethernet - Wikipedia

   en.wikipedia.org/wiki/Power_over_Ethernet

   Power over Ethernet (PoE) describes any of several standards or ad hoc systems that pass electric power along with data on twisted-pair Ethernet cabling. This allows a single cable to provide both a data connection and enough electricity to power networked devices such as wireless access points (WAPs), IP cameras and VoIP phones .

4. List of interface bit rates - Wikipedia

   en.wikipedia.org/wiki/List_of_interface_bit_rates

   Many device interfaces or protocols (e.g., SATA, USB, SAS, PCIe) are used both inside many-device boxes, such as a PC, and one-device-boxes, such as a hard drive enclosure. Accordingly, this page lists both the internal ribbon and external communications cable standards together in one sortable table.

5. Ethernet physical layer - Wikipedia

   en.wikipedia.org/wiki/Ethernet_physical_layer

   Many Ethernet adapters and switch ports support multiple speeds by using autonegotiation to set the speed and duplex for the best values supported by both connected devices. If autonegotiation fails, some multiple-speed devices sense the speed used by their partner, [ 1 ] but this may result in a duplex mismatch .

6. Fast Ethernet - Wikipedia

   en.wikipedia.org/wiki/Fast_Ethernet

   3Com 3C905B-TX 100BASE-TX PCI network interface card. 100BASE-TX is the predominant form of Fast Ethernet, and runs over two pairs of wire inside a Category 5 or above cable. Cable distance between nodes can be up to 100 metres (328 ft). One pair is used for each direction, providing full-duplex operation at 100 Mbit/s in each direction.

7. Autonegotiation - Wikipedia

   en.wikipedia.org/wiki/Autonegotiation

   Autonegotiation is a signaling mechanism and procedure used by Ethernet over twisted pair by which two connected devices choose common transmission parameters, such as speed, duplex mode, and flow control. In this process, the connected devices first share their capabilities regarding these parameters and then choose the highest-performance ...