enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Weep (architecture) - Wikipedia

   en.wikipedia.org/wiki/Weep_(architecture)

   Weep hole. A weep, a weep hole, or a weep-brick is a small opening that allows water to drain from within an assembly. Weeps are located at the bottom of the object to allow for drainage; the weep hole must be sized adequately to overcome surface tension.

3. Radon mitigation - Wikipedia

   en.wikipedia.org/wiki/Radon_mitigation

   Part of a radon mitigation system including the fan and vent pipe is visible near the gutter downspout. Because high levels of radon have been found in every state of the United States, [18] testing for radon and installing radon mitigation systems has become a specialized industry since the 1980s. Many states have implemented programs that ...

4. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.

5. Sleeve (construction) - Wikipedia

   en.wikipedia.org/wiki/Sleeve_(construction)

   For example, a 4" pipe, with 1" of thermal insulation makes a 6" penetrant (1" pipe covering on each side of the pipe), plus two pipe sizes = an 8" sleeve, creating a 1" annulus. In case of insulated piping, the size of the insulation must be taken into account for the intended firestop certification listing .

6. Air lock - Wikipedia

   en.wikipedia.org/wiki/Air_lock

   Depending on the pipe layout – if there are any upside down 'U's in the circuit – it will be necessary to vent the highest point(s). Otherwise, air lock may cause waterfall flow where the loss of hydraulic head is equal to the height of airlock; If the hydraulic grade line drops below the output of the pipe, the flow through that part of ...

7. Trap (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Trap_(plumbing)

   In domestic applications, traps are typically U, S, Q, or J-shaped pipe located below or within a plumbing fixture.An S-shaped trap is also known as an S-bend.It was invented by Alexander Cumming in 1775 but became known as the U-bend following the introduction of the U-shaped trap by Thomas Crapper in 1880.