Ads
related to: eye bolts without a hole in bottom
Search results
Results from the WOW.Com Content Network
Eye bolts. Machinery eye bolts are fully threaded and may have a collar, making them suitable for use with angular loads up to 45°. Eye bolts without a shoulder should not be used for angular loads. Heavy forged eye bolts with a continuous eye may be forged with an integral shoulder, allowing their use for heavy off-axis loads.
dowel screw. hanger bolt. handrail bolt. Similar to a wood screw but with two pointed ends and no head, used for making hidden joints between two pieces of wood. A hanger bolt has wood screw threads on one end and machine threads on the other. A hanger bolt is used when it is necessary to fasten a metal part to a wood surface.
A cranked eye bolt is an eye bolt typically used as a structural tie down [1] in building construction where the eye of the bolt must be fastened to a point that cannot be directly below where the shaft would otherwise be fastened. This often occurs where a bearer must be tied down to a post or column but the bearer cannot be directly fastened ...
torque controlled: the anchor is inserted into the hole and secured by applying a specified torque to the bolt head or nut with a torque wrench. A particular sub-category of this anchor is called wedge type. As shown in the figure, tightening the bolt results in a wedge being driven up against a sleeve, which expands it and causes it to ...
The first outer leg is inserted into the lewis hole, followed by the second outer leg. The inner (parallel) leg is inserted last, pushing the outer legs into contact with the inside of the lewis hole. The shackle is unbolted, placed over the legs, and the bolt fastened through both the shackle eyes and the eye in the top of each leg.
Normal bolts are manufactured to handle tension loads, whereas clevis pins and bolts are designed to withstand shearing forces. The sheering strength of a threaded bolt is determined by its inner thread diameter. Clevis pins should be closely fitted to the holes in the clevis to limit wear and reduce the failure rate of either the pin or the ...
Shear and bending forces are accommodated completely within the deck structure. In structural engineering and construction, an eyebar is a straight bar, usually of metal, with a hole ("eye") at each end for fixing to other components. Eyebars are used in structures such as bridges, in settings in which only tension, and never compression, is ...
Turnbuckle. Small (80 mm (35⁄32 in)) turnbuckle. A turnbuckle, stretching screw or bottlescrew is a device for adjusting the tension or length of ropes, cables, tie rods, and other tensioning systems. It normally consists of two threaded eye bolts, one screwed into each end of a small metal frame, one with a conventional right-hand thread and ...
Ads
related to: eye bolts without a hole in bottom