Search results
Results from the WOW.Com Content Network
Saturation arithmetic is a version of arithmetic in which all operations, such as addition and multiplication, are limited to a fixed range between a minimum and maximum value. If the result of an operation is greater than the maximum, it is set ("clamped") to the maximum; if it is below the minimum, it is clamped to the minimum. The name comes ...
The saturation flow is the rate at which a continuous flow of vehicles can pass through a constant green signal, typically expressed in vehicles per hour or PCUs per hour. [1] A formula to calculate saturation flows based on lane geometry is given in Transport and Road Research Laboratory RR67. [2]
In fluid dynamics, the Buckley–Leverett equation is a conservation equation used to model two-phase flow in porous media. [1] The Buckley–Leverett equation or the Buckley–Leverett displacement describes an immiscible displacement process, such as the displacement of oil by water, in a one-dimensional or quasi-one-dimensional reservoir.
The 1% false-positive rate can be reduced by a factor of ten by adding only about 4.8 bits per element. However, if the number of potential values is small and many of them can be in the set, the Bloom filter is easily surpassed by the deterministic bit array , which requires only one bit for each potential element.
where temperature T is in degrees Celsius (°C) and saturation vapor pressure P is in kilopascals (kPa). According to Monteith and Unsworth, "Values of saturation vapour pressure from Tetens' formula are within 1 Pa of exact values up to 35 °C." Murray (1967) provides Tetens' equation for temperatures below 0 °C: [3]
Inverted logistic S-curve to model the relation between wheat yield and soil salinity. Many natural processes, such as those of complex system learning curves, exhibit a progression from small beginnings that accelerates and approaches a climax over time.
The saturation with respect to water cannot be measured much below –50 °C, so manufacturers should use one of the following expressions for calculating saturation vapour pressure relative to water at the lowest temperatures – Wexler (1976, 1977), [1] [2] reported by Flatau et al. (1992)., [3] Hyland and Wexler (1983) or Sonntag (1994 ...
Brélaz defines this number as the degree of saturation of a given vertex. [1] The contraction of the term "degree of saturation" forms the name of the algorithm. [2] DSatur is a heuristic graph colouring algorithm, yet produces exact results for bipartite, [1] cycle, and wheel graphs. [2] DSatur has also been referred to as saturation LF in ...