Search results
Results from the WOW.Com Content Network
A flitch beam (or flitched beam) is a compound beam used in the construction of houses, decks, and other primarily wood-frame structures. Typically, the flitch beam is made up of a vertical steel plate sandwiched between two wood beams, the three layers being held together with bolts. In that common form it is sometimes referenced as a steel ...
A PSL block. Parallel-strand lumber (PSL) is a form of engineered wood made from parallel wood strands bonded together with adhesive. It is used for beams, headers, columns, and posts, among other uses. The strands in PSL are clipped veneer elements having a least dimension of not more than 1⁄4 inch (6.4 mm) and an average length of at least ...
A T-beam (or tee beam), used in construction, is a load-bearing structure of reinforced concrete, wood or metal, with a capital 'T'-shaped cross section. The top of the T-shaped cross section serves as a flange or compression member in resisting compressive stresses. The web (vertical section) of the beam below the compression flange serves to ...
Beam (structure) A statically determinate beam, bending (sagging) under a uniformly distributed load. A beam is a structural element that primarily resists loads applied laterally across the beam's axis (an element designed to carry a load pushing parallel to its axis would be a strut or column). Its mode of deflection is primarily by bending ...
Scarf joint. The scarf joint used on the beams above the post is known by its French name, trait de jupiter, or bolt-o-lightning joint. A scarf joint, or scarph joint, is a method of joining two members end to end in woodworking or metalworking. [1] The scarf joint is used when the material being joined is not available in the length required.
Timber design or wood design is a subcategory of structural engineering that focuses on the engineering of wood structures. Timber is classified by tree species (e.g., southern pine, douglas fir, etc.) and its strength is graded using numerous coefficients that correspond to the number of knots, the moisture content, the temperature, the grain ...
When testing wood in lumber form, the Janka test is always carried out on wood from the tree trunk (known as the heartwood), and the standard sample (according to ASTM D143) is at 12% moisture content and clear of knots. [3] The hardness of wood varies with the direction of the wood grain. Testing on the surface of a plank, perpendicular to the ...
Lumber is the most common and widely used method of sawing logs. Plain sawn lumber is produced by making the first cut on a tangent to the circumference of the log. Each additional cut is then made parallel to the one before. This method produces the widest possible boards with the least amount of log waste.