enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. High pressure injection injury - Wikipedia

   en.wikipedia.org/wiki/High_pressure_injection_injury

   The majority of high-pressure guns and injectors reach pressures of 2000 to 12000 pounds per square inch (psi), [6] but the ejection pressure must be at least 100 psi to penetrate human skin. [ 9 ] Treatment

3. Hydraulic ram - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_ram

   Thus if the source is 2 metres (6.6 ft) above the ram and the water is lifted to 10 metres (33 ft) above the ram, only 20% of the supplied water can be available, the other 80% being spilled via the waste valve. These ratios assume 100% energy efficiency. Actual water delivered will be further reduced by the energy efficiency factor.

4. Oshkosh MB-5 - Wikipedia

   en.wikipedia.org/wiki/Oshkosh_MB-5

   To the right of the turret was a selection lever, which would allow the turret to output foam or water depending on the turret operator's selection. A diagram of the MB-5's front hose reel. The handline was designed by Ardmore Mfg Co and was fed by a 150 pounds per square inch (1,000 kPa) centrifugal pump (built by Waterous Pump Co). [3]

5. Comparison of pumps - Wikipedia

   en.wikipedia.org/wiki/Comparison_of_pumps

   Different types of pumps are suitable for different applications, for example: a pump's maximum lift height also determines the applications it can be used for. Low-lift pumps are only suitable for the pumping of surface water (e.g., irrigation, drainage of lands, ...), while high-lift pumps allow deep water pumping (e.g., potable water pumping ...

6. Circulator pump - Wikipedia

   en.wikipedia.org/wiki/Circulator_pump

   This avoids one of the principal challenges faced by the larger, two-part pumps: maintaining a water-tight seal at the point where the pump drive shaft enters the pump body. Small- to medium-sized circulator pumps are usually supported entirely by the pipe flanges that join them to the rest of the hydronic plumbing. Large pumps are usually pad ...

7. Hydraulic pump - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_pump

   These pumps are used for high flows at relatively low pressure (max 100 bars (10,000 kPa)). [ clarification needed ] They were used on board ships where a constant pressure hydraulic system extended through the whole ship, especially to control ball valves [ clarification needed ] but also to help drive the steering gear and other systems.