Search results
Results from the WOW.Com Content Network
Grease fitting on a bearing A grease nipple on the driver's door of a 1956 VW Beetle. A grease fitting, grease nipple, Zerk fitting, grease zerk, Alemite fitting, or divit is a metal fitting used in mechanical systems to feed lubricants, usually lubricating grease, into a bearing under moderate to high pressure using a grease gun.
A grease gun (pneumatic) A grease gun is a common workshop and garage tool used for lubrication. The purpose of the grease gun is to apply lubricant through an aperture to a specific point, usually from a grease cartridge to a grease fitting or 'nipple'. The channels behind the grease nipple lead to where the lubrication is needed.
The M3 is an American .45-caliber submachine gun adopted by the U.S. Army on 12 December 1942, as the United States Submachine Gun, Cal. .45, M3. [12] The M3 was chambered for the same .45 ACP round fired by the Thompson submachine gun , but was cheaper to mass produce and lighter, at the expense of accuracy. [ 12 ]
Lincoln patented the first lever grease gun to work with a full stroke operation called the Model 1242. This meant that a hand-held grease gun could generate up to 10,000 lbf/in² (70 MPa) of pressure. Operators of the unit could push grease into blocked or "frozen" fittings and the unit allowed for work in confined areas.
As with their air-actuated cousins, powder-actuated guns have a muzzle safety interlock. If the muzzle is not pressed against a surface with sufficient force, the firing pin is blocked and cannot reach the load to fire it. This helps ensure that the gun does not discharge in an unsafe manner, causing the nail to become an unrestrained projectile.
Cleco (Cleko) fasteners on an aircraft wing. A cleco, also spelled generically cleko, is a temporary fastener developed by the Cleveland Pneumatic Tool Company. [1] Widely used in the manufacture and repair of aluminum-skinned aircraft, it is used to temporarily fasten sheets of material together, or to hold parts such as stiffeners, frames etc together, before they are permanently joined.
This edit by 75.131.110.5 removed every mention of the inventor of the grease fitting, Oscar Ulysses Zerk, and the word Zerk. This seems like vandalism. I've put back the fact that Zerk invented it, but the vandal did quite a job and I don't feel up to fixing every removal of "Zerk". Vaughan Pratt 04:59, 26 January 2018 (UTC)
The peening face or ball face is useful for rounding off edges of metal pins and fasteners, such as rivets. It can also be used to make gaskets for mating surfaces: a suitable gasket material is held over the surface that needs a gasket, and the operator lightly taps around the edges of the mating surface to perforate the gasket material. [6]