Search results
Results from the WOW.Com Content Network
A stall that results in the complete disruption of the airflow through the compressor is referred to as a compressor surge. The severity of the phenomenon ranges from a momentary power drop barely registered by the engine instruments to a complete loss of compression in case of a surge, requiring adjustments in the fuel flow to recover normal ...
While fully developed compressor surge is axisymmetric, its initial phase is not necessarily axisymmetric. Actually, severe damage of compressor surge is often related to very large transverse loads on blades and casing in its initial transient. [7] A chain reaction of compressor surge is the flameout of a jet engine. Due to a lack of air ...
Surge control line is the line which works as the indicating line for the surge control mechanism so that surge can be prevented in the system and proper steps can be taken. The line can vary for different surge control systems as it is up to the system to decide the margin between operating point and the surge point. [13]
Compressor surge is a particular problem during slam-accelerations and can be overcome by suitable adjustments to the fueling schedule and/or use of blow-off (bleeding air off the compressor, for handling purposes). In the particular example shown, a slam-acceleration from ground idle would cause a high-pressure compressor surge.
In the case of airfoils, the pressure field modification results in an increase in pressure drag, and if severe enough will also result in stall and loss of lift, all of which are undesirable. For internal flows, flow separation produces an increase in the flow losses, and stall-type phenomena such as compressor surge, both undesirable ...
Good pipeline control (start-up and shut-down procedures). Water towers (used in many drinking water systems) or surge tanks help maintain steady flow rates and trap large pressure fluctuations. Air vessels such as expansion tanks and some types of hydraulic accumulators work in much the same way as water towers, but are pressurized. They ...
The sound produced by compressor surge is called turbo flutter and the repeated, high speed cycling will cause a cyclic torque on the compressor and may lead to increased stresses on the bearings and compressor impeller. [2] A blowoff valve is designed to release pressure in the intake system when the throttle is closed.
Surge control products have been used in many industries to protect the maximum working pressure of hydraulic system for decades. Typical applications for surge relief equipment is in pipelines at pump stations, receiving manifolds at storage facilities, back pressure control, marine loading/off loading, site specific applications where pressure surges are generated by the automation system ...