Search results
Results from the WOW.Com Content Network
MCA-Jet was a simpler system that sent the same air/fuel mixture to all intake and MCA-Jet valves. Each MCA-Jet valve is quite small and may be prone to carbon build-up, causing the MCA-Jet valve(s) to stick open. If a Mitsubishi-designed engine has low compression, the MCA-Jet valve(s) could be the cause. Each MCA-Jet valve and valve seat are ...
The Mitsubishi Vulcan engine, identified by the code 2G2, is an iron-block twin cylinder engine with three main bearings, built by Mitsubishi Motors for kei car class vehicles from September 1972. It was an overhead camshaft design, and superseded the older two-stroke 2G1 series. The 2G2 was in turn replaced by the Multi-valve 3G8 three ...
The SOHC eight-valve 4G54 (also known as the G54B) displaces 2.6 L (2,555 cc), with bore & stroke at 91.1 mm × 98 mm (3.59 in × 3.86 in). The G54B for the US market had a cylinder head with additional jet valves to improve emissions (MCA-Jet system).
The 1.6-litre MCA-Jet four as the smaller sedans and coupes was standard with the 2.6-litre, 105 hp (78 kW) Astron engine optional as well as a five-speed manual transmission. [9] While the last year for the Lancer-based Colts was 1979, the wagon was continued alongside the front-wheel drive Mirage-based fourth generation models until 1981 when ...
A version with an early iteration of Mitsubishi's MCA lean-burn system (MCA-IIB), fulfilling the intermediate Japanese exhaust regulations for 1975, was called G32A. This was built for less than one year, as the new MCA engine arrived in November 1975. Those with the later, cleaner yet, "MCA-Jet" system were called G32B.
Mitsubishi introduced the MCA-Jet engine for Japan and other emissions-controlled markets with its latest Galant. This incorporated the "Jet Valve", a secondary intake valve which improved emissions without necessitating the need for a completely redesigned cylinder head.
This version could switch between breathing through two or three valves per cylinder, to combine high top-end power with low-end drivability as well as allowing for economical operation. [1] It was a modification of Mitsubishi MCA-Jet technology which used a secondary intake valve to inject air into the engine for more efficient emissions ...
All jet engines require high temperature gas for good efficiency, typically achieved by combusting hydrocarbon or hydrogen fuel. Combustion temperatures can be as high as 3500K (5841F) in rockets, far above the melting point of most materials, but normal airbreathing jet engines use rather lower temperatures.