Search results
Results from the WOW.Com Content Network
A separate connector is provided for DC power. [1] A 'universal' cable would have four drive connectors, two for each size of FDD, although cables which have only two drive connectors are common. The cable is normally a ribbon cable. For IBM-compatible floppy controllers, a twist in the cable reverses the order of conductors 10 through 16 for ...
The first Princeton, the "Woody" (so called for its uncovered wooden cabinet), was the smallest of the original Fender line of three amplifiers, an incredibly basic 3-watt practice amp with no controls at all, not even a power switch. [2] The first widely produced Princeton, the 1948 tweed-covered "TV front," used one 6SL7 or 6SC7 dual-triode ...
VirtualLink was a proposed USB-C Alternate Mode that was historically intended to allow the power, video, and data required to power virtual reality headsets to be delivered over a single USB-C cable instead of a set of three different cables as it was in older headsets. [1] [2] The standard was supported by Nvidia, AMD, HTC Vive, Oculus VR ...
The power connector on the 3½-inch floppy drive, informally known as "the Berg connector", is 2.50 mm pitch (distance from center to center of pins). The power cable from the ATX power supply consists of 20 AWG wire to a 4-pin female connector. [ 1 ]
This is a unique-looking barrel connector, apparently intended for providing a DC output jack (most DC jacks are used for power input). Possibly available in multiple voltage ranges, the one for voltage classification 2 (3.15 to 6.3 V) has an outside diameter of 4.75 mm and a protruding pin of 2.5 mm diameter. Previously known as EIAJ RCX-5321.
Left: 20-way grey ribbon cable with wire for pin 1 marked red, insulation partly stripped. Right: 16-way rainbow ribbon with IDC connector. IDC D-sub connectors DE-9 (male) and DA-15 (female) Twisted ribbon cable used for Parallel SCSI connections. A ribbon cable is a cable with many conducting wires running parallel to each other on the same ...
Power management ICs are solid-state devices that control the flow and direction of electrical power. Many electrical devices use multiple internal voltages (e.g., 5 V, 3.3 V, 1.8 V, etc.) and sources of external power (e.g., wall outlet, battery, etc.), meaning that the power design of the device has multiple requirements for operation. A PMIC ...
The driver ADP3418 chip (bottom left), used for driving high-power field transistors in voltage converters. Above it is seen next to such a transistor (06N03LA), probably driven by that driver. In electronics , a driver is a circuit or component used to control another circuit or component, such as a high-power transistor , liquid crystal ...