Search results
Results from the WOW.Com Content Network
PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).
[16] [17] For a comparison, a 500-watt power supply carrying the 80 Plus Bronze efficiency rating (which means that such a power supply is designed to be at least 82% efficient for loads above 100 W) may provide an 84% efficiency for a 100 W load, wasting only 19 W. [18] Other ratings such as 80 Plus Gold, 80 Plus Platinum and 80 Plus Titanium ...
The switch does not fully disconnect the device from its power supply. This may appear on a toggle switch opposite a power on symbol, alone on a pushbutton that places the device into a standby state, or alone on a button that switches between on and standby. Alternatively, under IEEE 1621, this symbol simply means "power". [9]
An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original 20-pin version. 20-pin Molex 39-29-9202 at the motherboard. 20-pin ...
An integrated power supply is one that shares a common printed circuit board with its load. An external power supply, AC adapter or power brick, is a power supply located in the load's AC power cord that plugs into a wall outlet; a wall wart is an external supply integrated with the outlet plug itself. These are popular in consumer electronics ...
The ATX specification defines the Power-Good signal as a +5-volt (V) signal generated in the power supply when it has passed its internal self-tests and the outputs have stabilized. This normally takes between 0.1 and 0.5 seconds after the power supply is switched on.
Use light grit sandpaper to remove carbon and soot buildup, then follow with compressed air to get rid of any residual debris before closing the panel and turning on the power and gas supply ...
A switchable power strip or power bar. Timers can be used to turn off standby power to devices that are unused on a regular schedule. Switches that turn the power off when the connected device goes into standby, [30] or that turn other outlets on or off when a device is turned on or off are also available. Switches can be activated by sensors.