Search results
Results from the WOW.Com Content Network
The figures below are simplex data rates, which may conflict with the duplex rates vendors sometimes use in promotional materials. Where two values are listed, the first value is the downstream rate and the second value is the upstream rate. The use of decimal prefixes is standard in data communications.
The data transfer rate of a drive (also called throughput) covers both the internal rate (moving data between the disk surface and the controller on the drive) and the external rate (moving data between the controller on the drive and the host system). The measurable data transfer rate will be the lower (slower) of the two rates.
The following table shows the names of the versions of the ATA standards and the transfer modes and rates supported by each. Note that the transfer rate for each mode (for example, 66.7 MB/s for UDMA4, commonly called "Ultra-DMA 66", defined by ATA-5) gives its maximum theoretical transfer rate on the cable.
In telecommunications, data transfer rate is the average number of bits , characters or symbols , or data blocks per unit time passing through a communication link in a data-transmission system. Common data rate units are multiples of bits per second (bit/s) and bytes per second (B/s).
Enhanced Small Disk Interface (ESDI) was an attempt to minimize controller design time by supporting multiple data rates with a standard data encoding scheme; this was usually negotiated automatically by the disk drive and controller; most of the time, however, 15 or 20 megabit ESDI disk drives were not downward compatible (i.e. a 15 or 20 ...
A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...
There are eight different UDMA modes, ranging from 0 to 6 for ATA (0 to 7 for CompactFlash), each with its own timing. 80-conductor cable used for modes faster than UDMA 2 on the left compared to a 40-conductor cable. Modes faster than UDMA mode 2 require an 80-conductor cable to reduce data settling times, lower impedance and reduce crosstalk. [1]
Data rate and data transfer rate can refer to several related and overlapping concepts in communications networks: Achieved rate. Bit rate, the number of bits ...