enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Positive locking device - Wikipedia

   en.wikipedia.org/wiki/Positive_locking_device

   A positive locking device is a device used in conjunction with a fastener in order to positively lock the fastener. This means that the fastener cannot work loose from vibrations. The following is a list of positive locking devices: [1] A split beam nut; A castellated nut and a split pin; A hex nut or cap screw and a tab washer

3. Latch - Wikipedia

   en.wikipedia.org/wiki/Latch

   A deadlocking latch bolt (deadlatch) is an elaboration on the latch bolt which includes a guardbolt to prevent "shimming" or "jimmying" of the latch bolt. When the door is closed, the latch bolt and guardbolt are retracted together, and the door closes normally, with the latch bolt entering the strike plate. The strike plate, however, holds the ...

4. Slim jim (lock pick) - Wikipedia

   en.wikipedia.org/wiki/Slim_jim_(lock_pick)

   A slim jim (more technically known as a lockout tool) is a thin strip of metal (usually spring steel) roughly 60 centimetres (24 in) long and about 2–4 centimetres (0.79–1.57 in) wide originally marketed under that name by HPC Inc., a manufacturer and supplier of specialty locksmithing tools.

5. Set screw - Wikipedia

   en.wikipedia.org/wiki/Set_screw

   A set screw is often headless and threaded along its entire length, so that it will sit entirely inside that hole; in which case it may be called a grub screw or blind screw. Once fully and firmly screwed into the first object, the projecting tip of the set screw presses hard against the second object, acting like a clamp .

6. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A machine screw or bolt is usually a smaller fastener (less than 1 ⁄ 4 inch (6.35 mm) in diameter) threaded the entire length of its shank that usually has a recessed drive type (slotted, Phillips, etc.), usually intended to screw into a pre-formed thread, either a nut or a threaded (tapped) hole, unlike a wood or self-tapping screw. Machine ...

7. Screw extractor - Wikipedia

   en.wikipedia.org/wiki/Screw_extractor

   A screw extractor held in a tap wrench. A screw extractor is a tool for removing broken or seized screws.There are two types: one has a spiral flute structure, commonly called an easy out after the trademarked name EZ-Out; [clarification needed] the other has a straight flute structure.