enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Display size - Wikipedia

   en.wikipedia.org/wiki/Display_size

   Display size. On 2D displays, such as computer monitors and TVs, display size or viewable image size (VIS) refers to the physical size of the area where pictures and videos are displayed. The size of a screen is usually described by the length of its diagonal, which is the distance between opposite corners, typically measured in inches.

3. List of scale model sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_scale_model_sizes

   Also known as "6 mm figure scale", the U.S. Army scale for sand-table wargames. The standard used in hobbyist miniature wargaming, where it is considered interchangeable with 1:300 scale. Commonly used for micro armor. 1:270: 1.129 mm Used by Fantasy Flight Games' Star Wars: X-Wing Miniatures Game for their small and large ships. 1:250: 1.219 mm

4. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

5. American wire gauge - Wikipedia

   en.wikipedia.org/wiki/American_wire_gauge

   By definition, 36 AWG is 0.005 inches in diameter, and 0000 AWG is 0.46 inches in diameter. The ratio of these diameters is 1:92, and there are 40 gauge sizes from 36 to 0000, or 39 steps. Because each successive gauge number increases cross sectional area by a constant multiple, diameters vary geometrically.

6. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   Unified Thread Standard. The Unified Thread Standard (UTS) defines a standard thread form and series—along with allowances, tolerances, and designations—for screw threads commonly used in the United States and Canada. It is the main standard for bolts, nuts, and a wide variety of other threaded fasteners used in these countries.

7. Gear inches - Wikipedia

   en.wikipedia.org/wiki/Gear_inches

   Gear inches is an imperial measure corresponding to the diameter in inches of the drive wheel of a penny-farthing bicycle with equivalent (direct-drive) gearing. A commonly used metric alternative is known as metres of development or rollout distance, which specifies how many metres a bicycle travels per revolution of the crank.