enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.

3. Modular connector - Wikipedia

   en.wikipedia.org/wiki/Modular_connector

   An 8P8C modular plug. This is the common crimp-type plug, of the same kind pictured above crimped onto a cable (with molded sleeve). A modular connector is a type of electrical connector for cords and cables of electronic devices and appliances, such as in computer networking, telecommunication equipment, and audio headsets.

4. D-subminiature - Wikipedia

   en.wikipedia.org/wiki/D-subminiature

   Crimp contacts are assembled by inserting a stripped wire end into a cavity in the rear of the contact, then crushing the cavity using a crimp tool, causing the cavity to grip the wire tightly at many points. The crimped contact is then inserted into the connector where it locks into place.

5. JIC fitting - Wikipedia

   en.wikipedia.org/wiki/JIC_fitting

   JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface. JIC (Joint Industry Council) fittings are widely used in fuel delivery and fluid power applications, especially where high pressure (up to 10,000 pounds per square inch (690 bar)) is involved.

6. Crimp (joining) - Wikipedia

   en.wikipedia.org/wiki/Crimp_(joining)

   Crimp tool for 0.14 mm 2 to 10 mm 2 (26–8 AWG) insulated and non-insulated ferrules. Crimping is a method of joining two or more pieces of metal or other ductile material by deforming one or both of them to hold the other. The bend or deformity is called the crimp. [1] [2] Crimping tools are used to create crimps.

7. Punch down tool - Wikipedia

   en.wikipedia.org/wiki/Punch_down_tool

   A punch down tool with interchangeable blades. A punch down tool, punchdown tool, IDC tool, or a Krone tool (named after the Krone LSA-PLUS connector), is a small hand tool used by telecommunication and network technicians.