Search results
Results from the WOW.Com Content Network
For manual transmission equipped cars, it is a component that replaces the stock gear selector (shifter). A shift kit usually shortens the throws of selecting a gear (also known as a short throw shift or short shifter), therefore allowing a driver to reduce the shift time and change gears more efficiently.
The AOD (automatic overdrive) is a four-speed automatic transmission, with the 4th gear as overdrive. Introduced in 1980, it was Ford's first four-speed automatic overdrive transmission. The gearset design is based on the Ford "X" automatic transmissions used during the 1950s, '60s, and '70s.
When it is switched on, an automatic transmission can shift into overdrive mode after a certain speed is reached (usually 70+ km/h [40-45 mph or more] depending on the load). When it is off, the automatic transmission shifting is limited to the lower gears. Overdrive should usually be selected when the average speed is above 70 km/h (40-45 mph).
TREMEC engineers have recommended Texaco-Havoline Dexron III/Mercon Non-Synthetic ATF. There has been a significant amount of confusion regarding the proper capacity and proper type of ATF for the TR-3650 which may have a correlation with a rather large number of complaints about notchy shifting, shift "nibbling", noisy synchros, and grinding gears.
Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation:
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The 4L80-E uses two shift solenoids, initially called Shift Solenoid A and Shift Solenoid B; they were later changed to comply with OBD-II regulations to 1-2 shift solenoid and 2-3 shift solenoid. By activating and deactivating the solenoids in a predetermined pattern by the PCM, four distinct gear ratios can be achieved.